The Orthogonal Machining Process Using Cutting Tools with Different Geometry

نویسنده

  • J. Zouhar
چکیده

This paper deals with modelling of the orthogonal machining process using tools with different geometries. The finite element method (FEM) is used for a simulation based on the Lagrangian formulation including ANSYS/LS-DYNA software. The constitutive Johnson – Cook material model regarding strain, strain rate and temperature to predict material plasticity and chip separation is used. Chip morphology, stress, strain, strain rate, residual stress and temperature have been obtained for a range of tool rake angles, cutting edge radii and friction coefficient values. Results are compared with experimental results and other references.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Investigation of Cutting Forces Superalloy Inconel 718

Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...

متن کامل

Modeling of hard part machining: effect of insert edge preparation in CBN cutting tools

High speed machining of hardened steels for manufacturing dies and molds offers various advantages, but the productivity often limited by mainly tool life. This study investigates the influence of edge preparation in cubic boron nitrite (CBN) cutting tools on process parameters and tool performance by utilizing practical finite element (FE) simulations and high speed orthogonal cutting tests. T...

متن کامل

Prediction of Surface in Machining by Flat and Spherical Surface Tools

In this paper, the profile of surfaces machined using end mills with flat and ball end tools in modeled. The real kinematics of the tool motion, the static deflection and the run out of the tool are included in the model. The cutting forces are calculated using a semi-empirical method based on orthogonal to oblique conversion of cutting coefficients. The thickness of the uncut chip is used as t...

متن کامل

Mechanics of high speed cutting with curvilinear edge tools

High speed cutting is advantageous due to the reduced forces and power, increased energy savings, and overall improved productivity for discrete-part metal manufacturing. However, tool edge geometry and combined cutting conditions highly affects the performance of high speed cutting. In this study, mechanics of cutting with curvilinear (round and oval-like) edge preparation tools in the presenc...

متن کامل

Influence of Water Cooling on Orthogonal Cutting Process of Ti-6Al-4V Using Smooth-Particle Hydrodynamics Method

Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2008