A New Structure for the NLC Positron Predamping Ring Lattice

نویسندگان

  • A. Wolski
  • Andrzej Wolski
چکیده

The NLC positron source is specified to produce a beam of normalized edge emittance 30,000 mm-mrad. It is not practicable, using a single damping ring, to damp this emittance to meet the specification for injection into the main linac, so a pre-damping ring is used to reduce the emittance to a value at least as small as that of the electron beam from the source. In this note, we describe the design of a pre-damping ring based on a double-bend achromatic structure, as opposed to the previously investigated theoretical minimum emittance cell. The lattice meets the specifications for damping and has close to the required acceptance, and has advantages over previous lattices, in terms of component specifications and design flexibility. CBP Tech Note-233 LCC-0066 A New Structure for the NLC Positron Pre-Damping Ring Lattice Andrzej Wolski Lawrence Berkeley National Laboratory

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Reduced Emittance Lattice for the NLC Positron Predamping Ring

This is an updated version of [1]. In the design presented there the horizontal emittance of the extracted beam is too large by about 20%. In order to get the emittance down to the required value the quadrupole magnets in the dispersive regions in the ring are moved to provide J_x=1.1 which gives a small enough emittance. In addition a better model of the wiggler fields is used. The new design ...

متن کامل

Optimization of Positron Capture in Nlc

In the Next Linear Collider design [1], the positron capture system includes a positron production target, followed by a short solenoid with a strong magnetic field (flux concentrator), a 250 MeV linac with solenoidal focusing, a 1.73 GeV linac with quadrupole focusing and an energy compressor system before injection into the positron pre-damping ring (see Fig. 1 for initial part of collector)....

متن کامل

The next Linear Collider Damping Ring Rf System

We report progress on the design of the RF systems for the Next LinearCollider (NLC) Damping Rings [1]. The 714MHz RF system is a critical component of the damping ring complex, and must provide flexible operation with high-power systems generating 1.5 MV in the main damping rings and 2 MV in the positron predamping ring. Average beam currents are approximately 750 mA, and bunch trains are rapi...

متن کامل

Improved Dynamics in the 180 Hz NLC Damping Rings

Adding a field gradient to the main dipoles for the NLC Main Damping Ring lattice has leads to significant improvements in the dynamic behavior of particles in the lattice. We describe the properties of the new lattice, including some initial estimates of alignment tolerances required to achieve the desired vertical emittance. CBP Tech Note-223 LCC-0055 Improved Dynamics in the 180 Hz NLC Dampi...

متن کامل

Novel Design for Photonic Crystal Ring Resonators Based Optical Channel Drop Filter

Photonic crystal ring resonators (PCRRs) are traditional structures fordesigning optical channel drop filters. In this paper, Photonic crystal channel drop filter(CDFs) with a new configuration of ring resonator is presented. The structure is made ofa square lattice of silicon rods with the refractive index nsi=3. 4 which are perforated inair with refractive index nair=1. Calculations of band s...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001