Ray chaos in optical cavities based upon standard laser mirrors.
نویسندگان
چکیده
We present a composite optical cavity made of standard laser mirrors; the cavity consists of a suitable combination of stable and unstable cavities. In spite of its very open nature the composite cavity shows ray chaos, which may be either soft or hard, depending on the cavity configuration. This opens a convenient route for experimental studies of the quantum aspects of a chaotic wave field.
منابع مشابه
Theoretical comparison analysis of long and short external cavity semiconductor laser
In this paper, considering optical feedback as an optical injection, and taking in to account round-trip time role in the external cavity, a standard small signal analysis is applied on laser rate equations. By considering the relaxation oscillation (f2) and external cavity frequencies (f) ratio for semiconductor laser, field amplitude response gain, optical phase and carrier number for long ex...
متن کاملAn Analytical Model for Rare Earth Doped Fiber Lasers Consisting of High Reflectivity Mirrors
The present article is concerned with an analytical solution for some parts of rare earth doped fiber laser equations. The presented model is valid for both four and three-level fiber lasers consisting high reflectivity mirrors. A typical method to obtain initial value in the numerical solutions of fiber laser equations is shooting method, which is based on an iteration process. Whereas this st...
متن کاملDesign of X-UV multilayers for high X-ray flux
2014 Many promising applications for multilayer X-ray optical elements 2014 X-ray laser cavities, plasma diagnostics, synchrotron optics, etc. 2014 subject them to intense X radiation. This paper discusses the initial attempts at understanding the physical processes that are likely to degrade the performance of multilayer X-ray mirrors, the selection of optimal pairs of materials to resist heat...
متن کاملNovel laser machining of optical fibers for long cavities with low birefringence.
We present a novel method of machining optical fiber surfaces with a CO₂ laser for use in Fiber-based Fabry-Perot Cavities (FFPCs). Previously FFPCs were prone to large birefringence and limited to relatively short cavity lengths (≤ 200 μm). These characteristics hinder their use in some applications such as cavity quantum electrodynamics with trapped ions. We optimized the laser machining proc...
متن کاملResonant pumped erbium-doped waveguide lasers using distributed Bragg reflector cavities.
This Letter reports on an optical pumping scheme, termed resonant pumping, for an erbium-doped distributed feedback (DFB) waveguide laser. The scheme uses two mirrors on either side of the DFB laser, forming a pump cavity that recirculates the unabsorbed pump light. Symmetric distributed Bragg reflectors are used as the mirrors and are designed by matching the external and internal quality fact...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Physical review. E, Statistical, nonlinear, and soft matter physics
دوره 68 4 Pt 2 شماره
صفحات -
تاریخ انتشار 2003