Pii: S0026-2692(98)00078-0
نویسندگان
چکیده
A new CMOS programmable balanced output transconductor (BOTA) is introduced. The BOTA is a useful block for continuous-time analog signal processing. A new CMOS realization based on MOS transistors operating in the saturation region is given. Application of the BOTA in realizing bandpass–lowpass–allpass–notch biquad mixed mode filter using four BOTAs and two grounded capacitors and in realizing current mode MOS-C oscillators using three or four BOTAs and two grounded capacitors are given. PSpice simulation results for the BOTA circuit and for its applications are also included. q 1998 Elsevier Science Ltd. All rights reserved.
منابع مشابه
Pii: S0026-2692(98)00127-x
We have successfully used (311)A and (511)A GaAs for the realization of high quality two-dimensional hole gas (2DHG) and electrons gas (2DEG) structures, respectively. This study was performed mostly on a back-gated, inverted interface, GaAs/AlGaAs structure, in which a 2DHG or 2DEG is embedded. This particular structure enabled the variation of the 2D carrier concentration over two orders of m...
متن کاملPii: S0026-2692(98)00111-6
The drive performance of a new MOSFET structure, the peak device, resulting from recent doping profile optimizations of a 0.25 mm nMOSFET for 1.5 V supply voltage, is investigated. Explanations for the improved performance are given using two-dimensional device simulation. With an analytical transistor model fitted to the two-dimensional device characteristics, the relevant physical effects are...
متن کاملPii: S0026-2692(00)00023-9
In this paper we analyse the trade-offs for a terahertz imaging system and discuss implementation of a terahertz micro antenna array for imaging. We also describe applications of terahertz imaging and improvements in the signal processing. q 2000 Elsevier Science Ltd. All rights reserved.
متن کاملPii: S0026-2692(00)00075-6
This paper presents a real case study on the testing of 8-bit mixed-signal CMOS micro-controller devices by applying the IDDQ testing methodology. The aim of the study is to evaluate the feasibility of using the IDDQ test to enhance the overall fault coverage. Failure analysis operated on the failed sample indicated a good correlation between the fault coverage and the parts that failed the IDD...
متن کامل