Conventional Hydraulic Nozzles Used for Orchard Applications
نویسندگان
چکیده
A conventional, axial‐flow, air‐blast orchard sprayer was used to make applications to the outside row of a semi‐dwarf apple block. Fluorescent tracer was applied at the same rate using either disc‐core nozzle sets or air‐induction nozzles fitted with flat‐fan tips. The experiment included measuring the percent area of spray coverage on leaves after three variations in spray application method. Each of the variations used a different type of nozzle on the same conventional, axial‐fan orchard sprayer. The three nozzle variations were a Spraying Systems D3‐25 nozzle set, a Spraying Systems D4‐25 nozzle set, and a TurboDrop 02 (TD02) air‐induction nozzle set. Canopy spray deposits, downwind sedimentation, and airborne spray losses were also measured following treatment on the inside half of the outside row using D4‐25 nozzles or TD02 nozzles. The small droplet spectrum D3‐25 nozzle set produced the highest leaf surface coverage on both upperside and underside surfaces at 2.0 and 3.0 m heights in the canopy. The upperside leaf surface coverage produced by the D3‐25 nozzle was only somewhat greater than the TD02 nozzle. It was, however, significantly higher than the D4‐25 nozzle set at the 3.0 m height. Conversely, the underside leaf surface coverage produced by the D3‐25 was significantly greater than the TD02 nozzle set at both 2.0 and 3.0 m heights and not statistically different from the D4‐25 nozzle set at the lower sampling height. There were relatively few differences in canopy spray deposits between the D4‐25 and TD02 nozzle sets. The TD02 treatment produced the lowest downwind sedimentation deposits on targets 8 to 32 m from the edge of the orchard. The D4‐25 produced approximately three times higher deposits up to 9 m above the ground than the TD02 treatment on passive nylon screens located 8 m downwind from the edge of the orchard. The D4‐25 treatment produced significantly higher airborne deposits on elevated, high‐volume, air sampler filters out to 64 m. At 128 m, sedimentation and airborne deposits were similar for the D4‐25 and TD02 treatments.
منابع مشابه
Comparison of field and model percentage drift using different types of hydraulic nozzles in pesticide applications
*Corresponding Author Email: [email protected] Tel./Fax: +90 322 338 6518 ABSTRACT: In pesticide applications, small droplets are desired for better coverage and uniform distribution. Yet, small droplets have a problem: Drift, the movement of droplets off-target. Low drift nozzle produces fewer drift-prone droplets, < 100 μm, compared to standard hydraulic nozzles. In pesticide applications, ...
متن کاملVertical and horizontal spray distribution of hollow cone nozzles in a wind tunnel: a preliminary study to mitigate spray drift in orchard applications
HAL is a multi-disciplinary open access archive for the deposit and dissemination of scientific research documents, whether they are published or not. The documents may come from teaching and research institutions in France or abroad, or from public or private research centers. L’archive ouverte pluridisciplinaire HAL, est destinée au dépôt et à la diffusion de documents scientifiques de niveau...
متن کاملThe Practical Use of Agdrift® and Other Drift Exposure Models for Aerial, Ground and Orchard Spray Applications
The practical use of spray drift databases and models for predicting drift exposure in pesticide applications is discussed. The AgDRIFT® model, developed by government and industry scientists in the US facilitates such assessments for various application scenarios. Aerial applications can be modelled using a predictive model that considers the effects of application, tank mix, meteorological an...
متن کاملMutual Collision of Water Jets from Adjacent High Pressure Flat Jet Nozzles on Flat Surfaces during Hydraulic Descaling
Original scientific paper High energetic water jets sprayed from nozzles are used for scale removal. Special nozzles with flat and very narrow jets for high feed pressure are used. This process, called descaling, is used in hot rolling, for example. A number of jets must be used to cover the total width of a rolled strip. High quality and homogeneity of the descaling process is required. A row ...
متن کاملDesign and Development of Variable Rate Spraying System Based on Canopy Volume Measurement
Variable rate spraying technology can improve the pesticide utilization ratio, reduce the waste of pesticide, and canopy volume was a very important variable rate reference in orchard spraying, so a variable rate spraying system based on canopy volume measurement was presented and developed. The system was mainly made up of PC, ultrasonic sensor, single chip, flow control mechanism and nozzles....
متن کامل