The New Bridge Converter Control Method
نویسندگان
چکیده
The article describes a new control method of transistor power bridge converter. It is a new one, because of some original solutions and its difference in comparison to existing methods. It’s irrelevant of load, similar to the “phase shifted” control method. It is easy to realize using ordinary electronic elements. A significant advantage of method is the possibility of permanent output current monitoring by measuring the voltage sag on a pair of transistors. That allows a very efficient current protection.
منابع مشابه
Design and Simulation of a New DC Power Supply Based on Dual Bridge Matrix Converter
A conventional high power DC power supply systems consist of a three-phase diode rectifier followed by a high frequency converter to supply loads at regulated DC voltage. These rectifiers draw significant harmonic currents from the utility, resulting in poor input power factor. In this paper, a DC power supply based on dual-bridge matrix converter (DBMC) with reduced number of switches is p...
متن کاملDevelopment of Average Model for Control of a Full Bridge PWM DC-DC Converter
This paper presents a detailed small-signal and transient analysis of a full bridge PWM DC-DC converter designed for high voltage, high power applications using an average model. The derived model is implemented in a typical system and used to produce the small-signal and transient characteristics of the converter. Results obtained in the analysis of the high voltage and high power design examp...
متن کاملSpeed Control of A Three Phase Current Forced Synchronous Machine Drive Based on A Simple Method
In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...
متن کاملSpeed Control of A Three Phase Current Forced Synchronous Machine Drive Based on A Simple Method
In this paper, a new method is proposed for the speed control of a three-phase current forced synchronous machine drive. This metohd is based on the use of an approximate constant commutation safety margin angle in the output thyristor bridge of the drive system as well as on the compenastion of stator magnetization reaction. The commutation process in the output converter of the machine driv...
متن کاملVoltage Regulation Using Phase Shift Modulation in Single-dc-source or Solar Voltage Source Using Cascaded H-bridge Multilevel Converters
Cascaded H-bridge multilevel power electronic converters generally require several dc sources. An alternative option is to replace all the separate dc sources feeding the H-bridge cells with capacitors, leaving only one H-bridge cell with a real dc voltage source. This will yield a cost-effective converter. However, the required capacitor voltage balancing is challenging. In this paper, using t...
متن کامل