Resonance investigation of pump-turbine during startup process
نویسندگان
چکیده
The causes of resonance of a certain model pump-turbine unit during startup process were investigated in this article. A three-dimensional full flow path analysis model which contains spiral case, stay vanes, guide vanes, runner, gaps outside the runner crown and band, and draft tube was constructed. The transient hydraulic excitation force of full flow path was analyzed under five conditions near the resonance region. Based on one-way fluidstructure interaction (FSI) analysis model, the dynamic stress characteristics of the pump-turbine runner was investigated. The results of pressure pulsation, vibration mode and dynamic stress obtained from simulation were consistent with the test results. The study indicated that the hydraulic excitation frequency (Zg*fn) Hz due to rotor-stator interference corresponding to the natural frequency of 2ND+4ND runner mode is the main cause of resonance. The relationship among pressure pulsation, vibration mode and dynamic stress was discussed in this paper. The results revealed the underlying causes of the resonance phenomenon.
منابع مشابه
Effects of Pump-turbine S-shaped Characteristics on Transient Behaviours: Model Setup
Pumped storage stations undergo numerous transition processes, which make the pump turbines go through the unstable S-shaped region. The hydraulic transient in S-shaped region has normally been investigated through numerical simulations, while field experiments generally involve high risks and are difficult to perform. In this research, a pumped storage model composed of a piping system, two mo...
متن کاملThree-dimensional transient simulation of a prototype pump-turbine during normal turbine shutdown
Three-dimensional numerical simulations are carried out by commercial software STAR-CCM+ to investigate the hydraulic transient and flow behaviours of a prototype pump-turbine during the normal shutdown process. The global characteristics and pressure fluctuations are analysed as the pump-turbine runs through the turbine mode, into the turbine braking mode, and finally into the reversed pump mo...
متن کاملCharacterization and Investigation of Grain Selection in Spiral Grain Selectors during Casting Single-Crystal Turbine Blades
Manufactured single crystal components using Ni-base super alloys are routinely used in the hot sections of aero engines and industrial gas turbines due to their outstanding high temperature strength, toughness and resistance to degradation in corrosive and oxidative environments. To control the quality of the single crystal turbine blades, particular attention has been paid to grain selection,...
متن کاملCharacterization and Investigation of Grain Selection in Spiral Grain Selectors during Casting Single-Crystal Turbine Blades
Manufactured single crystal components using Ni-base super alloys are routinely used in the hot sections of aero engines and industrial gas turbines due to their outstanding high temperature strength, toughness and resistance to degradation in corrosive and oxidative environments. To control the quality of the single crystal turbine blades, particular attention has been paid to grain selection,...
متن کاملNumerical and Economic Study of Performance of Centrifugal Pump as Turbine
In this paper, performance of centrifugal pump as turbine (PAT) is investigated numerically. Three different specific speeds are considered and three pumps are designed using diagrams from catalogues and CFturbo V.9 software. Next, models are analyzed by Ansys CFX 16 software and results are compared with those of CFturbo software. Also, a mesh study analysis for one case is performed in order ...
متن کامل