The optical properties of bismuth nanowires
نویسنده
چکیده
The optical absorption of bismuth nanowires in the energy (wavenumber) range of 600 4000cm-1 is studied. Optical reflection and transmission spectra reveal that bismuth nanowires have a large and intense absorption peak as well as several smaller absorption peaks which are not measured in bulk bismuth. The smaller absorption peaks fit reasonably well to theoretical models for intersubband absorption in bismuth nanowires. The wire diameter, polarization, and doping dependencies as well as the spectral shape of the dominant peak agree with simulations of the optical absorption resulting from an L-point valence to T-point valence band electronic transition. The large absorption peak is present even for nanowires too large to exhibit quantum confinement, thus showing that the absorption results from a surface-induced effect and not from quantum confinement. The enhanced optical absorption in nanowires over bulk bismuth is attributed to a surface term in the matrix element which results from the spacial gradient of the dielectric function and the large dielectric mismatch between bismuth and the surrounding alumina or air. A comparison of the measured spectra with simulations of optical absorption resulting from direct L-point electronic transitions demonstrated that this absorption mechanism is not dominant in our materials. In order to explore the optical properties of bismuth nanowires, two methods were developed. First, effective medium theory applied in reverse was used to deduce the dielectric function of materials smaller than the wavelength of light. Second, a technique to fabricate nanowires with diameters above 200nm was transfered into our laboratory. The enhanced coupling between the L-T point valence bands in nanowires may lead to a very accurate measurement of the band gap and band overlap in bismuth as a function of doping and temperature. In addition, the discovery of the enhanced interband coupling resulting from the surface contribution to the matrix element has many implications, especially if this result is applicable to other systems. Thesis Supervisor: Mildred S. Dresselhaus Title: Institute Professor
منابع مشابه
Reply to " Comment on ' Indirect L to T point optical transition in bismuth nanowires ' "
Citation Levin, A. J. et al. " Reply to "Comment on`Indirect L to T point optical transition in bismuth nanowires' ". Article is made available in accordance with the publisher's policy and may be subject to US copyright law. Please refer to the publisher's site for terms of use. The MIT Faculty has made this article openly available. Please share how this access benefits you. Your story matter...
متن کاملStructural Investigation, Physical and Optical Properties of Mixed Alkali Bismuth Borate Glasses
Lead free, eco-friendly bismuth borate glasses doped with alkali oxides of composition xLi2O+(30-x)Na2O+55B2O3+15Bi2O3 (x = 5,10,15,20,25) were prepared by melt quenching technique. Amorphous nature of glasses was confirmed by X-ray diffraction. Density measurements were carried out at room temperature by standard principle of Archimedes with Xylene as an immersion liquid. The non-linear ...
متن کاملOptical Properties of ZnO Nanowires and Nanorods Synthesized by Two Step Oxidation Process
ZnO nanowires with a diameter of 70 nm and nanorods with a diameter in the range of 100-150 nm and two micrometer in length were grown on glass substrates by resistive evaporation method and applying a two step oxidation process at low temperatures, without using any catalyst, template or buffer layer. XRD pattern of these nanostructures indicated a good crystallinity property with wurtzite hex...
متن کاملStructural and Optical Properties of Sr-Modified Bismuth Silicate Nanostructured Films Synthesized by Sol Gel Method
In this work, the effects of strontium addition on the structure and optical properties of nanostructured bismuth silicate (Bi4Si3O12) thin films prepared via sol-gel were studied. At first, different sols containing the optimum ratio of precursors were synthesized, and then, the prepared sols were coated on the substrate via dip coating. The dip coated samples were dried at 100oC and, in order...
متن کاملImproving the optical properties of thin film plasmonic solar cells of InP absorber layer using nanowires
In this paper, a thin-film InP-based solar cell designed and simulated. The proposed InP solar cell has a periodic array of plasmonic back-reflector, which consists of a silver layer and two silver nanowires. The indium tin oxide (ITO) layer also utilized as an anti-reflection coating (ARC) layer on top. The design creates a light-trapping structure by using a plasmonic back-reflector and an an...
متن کامل