Investigation of Grain Flow Microstructure in Forged Nitronic 50 Stainless Steel
نویسندگان
چکیده
Samples were sectioned with observation surface parallel to the normal of the short transverse direction (ST) that were removed from Block B as shown in Figures 1 and 2. A sample was polished and then etched with Agua Regia. The sample was then analyzed in a Leica MEF4M metallograph to observe microstructure and then analyzed in a Zeiss 1540 XB Field Emission Gun Scanning Electron Microscope (FEGSEM).
منابع مشابه
Flow stress of Nitronic-50 stainless steel over a wide range of strain rates and temperatures
To understand and model the thermomechanical response of Nitronic-50 stainless steel, uniaxial compression tests are performed on cylindrical samples, using an Instron servohydraulic testing machine and an enhanced Hopkinson technique. True strains exceeding 60% are achieved in these tests, over the range of strain rates from 0.001/s to 8000/s, and at initial temperatures from 77 K to 1000 K. T...
متن کاملStrain Evolution in Cold-Warm Forged Steel Components Studied by Means of EBSD Technique
Electron BackScatter Diffraction (EBSD) in conjunction with Field-Emission Environmental Scanning Electron Microscopy (FEG-ESEM) has been used to evaluate the microstructural and local plastic strain evolution in different alloys (AISI 1005, AISI 304L and Duplex 2205) deformed by a single-stage cold and warm forging process. The present work is aimed to describe the different behavior of the au...
متن کاملThe Effect of Friction Stir Processing Speed Ratio on the Microstructure and Mechanical Properties of A 430 Ferritic Stainless Steel
This study is an attempt to investigate the effect of welding rotational and traverse speed on mechanical and microstructural properties of A 430 stainless steel in order to give an effective processing window to achieve an appropriate microstructure and so mechanical properties. There are a wide range industrial uses for ferritic stainless steel. There from they have some problems like grain c...
متن کاملMicrostructural evolution of 304 austenitic stainless steel in friction stir welding process
Friction stir welding (FSW) was conducted on AISI 304 austenitic stainless steel plate with 2 mm thickness. The FSW was performed at a welding and rotational speeds of 50 mm/min and 400 rpm, respectively. Microstructure observations by the optical microscopy showed that a severe grain refinement occurred in the stir zone (SZ). Electron backscattered diffraction analysis (EBSD) results indicated...
متن کاملEffect of Thermomechanical Processing on the Microstructure and Mechanical Properties of a Duplex Stainless Steel
Duplex stainless steels (DSSS) have a microstructure composed of ferrite and austenite phases that gives them a very good combination of mechanical and corrosion properties. These steels are desirable for many applications in the chemical and petrochemical industries. In the present study, a type of stainless steel was cast, solution annealed at 1200°C for 60 min and then quenched in water. Ini...
متن کامل