Inhibition of Copper Corrosion by self Assembled Amphiphiles

نویسنده

  • J. Telegdi
چکیده

The advantage of nanolayers that can replace the traditional inhibitors of solids is the significant decrease in chemicals. The consequence is a lower environmental pollution. On a copper surface, special hydroxamic acid amphiphiles (CnH2n+1CONHOH, n = 9–17) were used in self-assembled molecular layers (SAM). The impact of time in SAM formation as well as the carbon chain length in the amphiphilic molecules was in the focus of the experiments. The time-dependent layer structure was characterized by sum frequency vibrational spectroscopy. The anti-corrosion efficiency of nanolayers was measured by different electrochemical techniques (electrode impedance spectroscopy, polarization) and by micro-calorimeter. The comparative analysis of data proved that the increase in time of SAM formation up to 1 hour enhances the stability, the ordering as well as the efficiency of nanolayers. The length of the carbon chain in the SAM layer, less significantly increases the anticorrosion efficiency in a corrosive environment than the layer thickness in LB films.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Preparation and Anticorrosion of Octadecyl Trichlorosilane SAMs for Copper Surface

The self-assembled monolayer (SAM) was prepared using octadecyl trichlorosilane (OTS) in distilled solution on the copper surface. The effect of inhibitor concentration on the rate of inhibition efficiency and corrosion rate in corrosion medium on copper by using polarization curves, electrochemical impedance spectroscopy (EIS), scanning electron microscope (SEM) was studied. The results showed...

متن کامل

An impedance investigation of corrosion protection of copper by self-assembled monolayers of alkanethiols in aqueous solution

Self-assembled monolayers (SAMs) of three n-alkanethiols, 1-octadecanethiol (C18SH), 1-dodecanethiol (C12SH), and 1-hexanethiol (C6SH), were formed on fresh, oxide-free copper surfaces obtained by HNO3 etching. The corrosion protection abilities of the three alkanethiol SAMs were evaluated in 0.2 mol cm-3 NaCl, 0.2 mol cm-3 HCl and 0.2 mol dm–3 H2SO4 solutions using the electrochemical impedanc...

متن کامل

Corrosion Protection of Copper with Hybrid Sol-Gel Containing 1H-1, 2, 4-triazole-3-thiol

To improve the corrosion protection of copper metal, 0.01M concentration of 1H-1,2,4-triazole-3-thiol (TAT) was incorporated into the hybrid sol-gel monolayers containing 3-glycidoxypropyltrimethoxysilane (GPTMS) and Tetraethoxysilane (TEOS). It was further subjected to hydrolysis and condensation reaction to form a sol-gel matrix. The TAT-doped hybrid sol-gel coating was applied over the c...

متن کامل

Modification of Copper with Self-assembled Thiol Monolayers

Self-assembled monolayers (SAM) make the creation of new types of protective layers possible, concerning corrosion, with which ecologically damaged procedures would be replaced for the protection of metal constructions from corrosion. Self-assembling is a spontaneous process which is developed by submerging of suitable metal substract into the melt with surface organic active substance, which i...

متن کامل

Inhibition of Copper Corrosion by Ethanolamine in 100 ppm NaCl

We study copper corrosion inhibition by ethanolamine (ETA)with (0, 0.2 ,0.3,0.4,0.5) vol.% concentrations in 100 ppm NaCl solution. This work is carried out by potentiodynamic measurements and Electrochemical Impedance Spectroscopy (EIS). The substrates' surface morphologies are examined by Scanning Electron Microscopy (...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2007