A Hamiltonian approach for the optimal control of the switching signal for a DC-DC converter
نویسندگان
چکیده
The optimal control problem of a switching DC-DC converter is considered in this paper. An LQ (Linear Quadratic) type performance index of the error between the current state variables and the target working point is defined. The feedback control on the decision variable of the duty cycle frequency is then formulated as a minimization of an appropriate Hamiltonian function of which suboptimal solutions are proposed. These are based on a detailed study of the average model of the system, obtained from the desired steady state solution. This paper focuses on a particular converter (the Buck-Boost converter), but the results are easily extensible to all single switch-cell converters.
منابع مشابه
A High Efficiency Low-Voltage Soft Switching DC–DC Converter for Portable Applications
This paper presents a novel control method to improve the efficiency of low-voltage DC-DC converters at light loads. Pulse Width Modulation (PWM) converters have poor efficiencies at light loads, while pulse frequency modulation (PFM) control is more efficient for the same cases. Switching losses constitute a major portion of the total power loss at light loads. To decrease the switching losses...
متن کاملA Soft Switched DC-DC Boost Converter for Use in Grid Connected Inverters
This paper presents a soft-switching DC-DC boost converter, which can be utilized in renewable energy systems such as photovoltaic array, and wind turbine connections to infinite bus of a big power network, using grid connected inverters. In the proposed topology for the DC-DC boost converter, the main and the auxiliary power switches are turned on and turned off with zero voltage switching (ZV...
متن کاملSliding Mode Control of a Bidirectional Buck/Boost DC-DC Converter with Constant Switching Frequency
In this paper, sliding mode control (SMC) for a bidirectional buck/boost DC-DC converter (BDC) with constant frequency in continuous conduction mode (CCM) is discussed. Since the converter is a high-order converter, the reduced-order sliding manifold is exploited. Because of right-half-plan zero (RHPZ) in the converter’s duty ratio to output voltage transfer function, sliding mode current...
متن کاملDevelopment of Average Model for Control of a Full Bridge PWM DC-DC Converter
This paper presents a detailed small-signal and transient analysis of a full bridge PWM DC-DC converter designed for high voltage, high power applications using an average model. The derived model is implemented in a typical system and used to produce the small-signal and transient characteristics of the converter. Results obtained in the analysis of the high voltage and high power design examp...
متن کاملVoltage Regulation of DC-DC Series Resonant Converter Operating in Discontinuous Conduction Mode: The Hybrid Control Approach
Dynamic modeling and control of dc-dc series resonant converter (SRC) especially when operating in discontinuous conduction mode (DCM) is still a challenge in power electronics. Due to semiconductors switching, SRC is naturally represented as a switched linear system, a class of hybrid systems. Nevertheless, the hybrid nature of the SRC is commonly neglected and it is modeled as a purely contin...
متن کاملA Repetitive Control- based Approach for Power Sharing among Boost Converters in DC Microgrids
In this paper a repetitive control (RC) approach to improve current sharing between parallel-connected boost converters in DC microgrids is presented. The impact of changes in line impedance on current sharing is investigated. A repetitive controller is designed and connected in series with current controller of the boost converters to control the switching signals such that by regulating of th...
متن کامل