Finding the Generalized Forces of a Series-Parallel Manipulator
نویسندگان
چکیده
In this work the kinematic and dynamic analyses of a robot manipulator whose topology consists of parallel kinematic structures with linear actuators are approached by means of the theory of screws and the principle of virtual work. The input/output equations of velocity and acceleration are obtained by applying screw theory. Then the generalized forces of the manipulator are determined combining screw theory and the principle of virtual work. Finally, a case study, whose numerical results are compared with simulations generated with the aid of specialized software, is included.
منابع مشابه
Kinematic and Dynamic Analysis of Tripteron, an Over-constrained 3-DOF Translational Parallel Manipulator, Through Newton-Euler Approach
In this research, as the main contribution, a comprehensive study is carried out on the mathematical modeling and analysis of the inverse kinematics and dynamics of an over-constraint three translational degree-of-freedom parallel manipulator. Due to the inconsistency between the number of equations and unknowns, the problem of obtaining the constraint forces and torques of an over-constraint m...
متن کاملStochastic Comparisons of Series and Parallel Systems with Heterogeneous Extended Generalized Exponential Components
In this paper, we discuss the usual stochastic‎, ‎likelihood ratio, ‎dispersive and convex transform order between two parallel systems with independent heterogeneous extended generalized exponential components. ‎We also establish the usual stochastic order between series systems from two independent heterogeneous extended generalized exponential samples. ‎Finally, ‎we f...
متن کاملA Novel Generalized Topology for Multi-level Inverter with Switched Series-parallel DC Sources (RESEARCH NOTE)
This paper presents a novel topology of single-phase multilevel inverter for low and high power applications. It consists of polarity (Level) generation circuit and H Bridge. The proposed topology can produce higher output voltage levels by connecting dc voltage sources in series and parallel. The proposed topology utilizes minimum number of power electronic devices which helps in reduction o...
متن کاملNear-Minimum-Time Motion Planning of Manipulators along Specified Path
The large amount of computation necessary for obtaining time optimal solution for moving a manipulator on specified path has made it impossible to introduce an on line time optimal control algorithm. Most of this computational burden is due to calculation of switching points. In this paper a learning algorithm is proposed for finding the switching points. The method, which can be used for both ...
متن کامل3-RPS Parallel Manipulator Dynamical Modelling and Control Based on SMC and FL Methods
In this paper, a dynamical model-based SMC (Sliding Mode Control) is proposed fortrajectory tracking of a 3-RPS (Revolute, Prismatic, Spherical) parallel manipulator. With ignoring smallinertial effects of all legs and joints compared with those of the end-effector of 3-RPS, the dynamical model ofthe manipulator is developed based on Lagrange method. By removing the unknown Lagrange multipliers...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2013