1 Using Ohm ’ s Law to Calibrate a Picoammeter to 0 . 4 Pico - ampere Precision

نویسندگان

  • Joseph Hashem
  • Tiankuan Liu
  • Zhihua Liang
  • Jingbo Ye
چکیده

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Using Ohm's Law to Calibrate a Picoammeter to 0.4 Pico-ampere Precision

We present an experimental method based on Ohm’s Law to calibrate the Keithley 6485 picoammeter with the calibration error less than 0.4 pico-ampere (pA), which is specified as the highest sensitivity of this instrument. The maximum calibration difference between the measurement current and the calibration current in the picoammeter’s 2 nano-ampere (nA) range is 0.25 pA. This difference is far ...

متن کامل

Cable Anatomy I: Understanding the Speaker Cable

How big should the conductors be? The required size (or gauge) of the conductors depends on three factors: (1) the load impedance; (2) the length of cable required; and (3) the amount of power loss that can be tolerated. Each of these involves relationships between voltage (volts), resistance (ohms), current (amperes) and power (watts). These relationships are defined with Ohm’s Law. The job of...

متن کامل

Design, Development and Simulations of MHD Equations with its proto type implementations

The equations of motion of conducting fluid in a magnetic field are formulated. These consist of three sets. First is the mass conservation equation, second Navier Stokes equation which is Newton’s second law taking into account the force of magnetic field on moving charges. The electrical field effects are neglected as is usually done in MHD. The third set is Maxwell’s equation especially to m...

متن کامل

A Double PWM Source Inverter Technique with Reduced Leakage Current for Application on Standalone Systems

The photovoltaic (PV) panel with no galvanic isolation system is well known technique in the world which is effective and delivers power with enhanced efficiency. The PV generation presented here is for stand-alone system installed in remote areas when as the resulting power gets connected to electronic load installation instead of being tied to the grid. Though very small, even then transforme...

متن کامل

Energy decay for Maxwells equations with Ohms law in partially cubic domains

We prove a polynomial energy decay for the Maxwell’s equations with Ohm’s law in partially cubic domains with trapped rays. We extend the results of polynomial decay for the scalar damped wave equation in partially rectangular or cubic domain. Our approach have some similitude with the construction of re‡ected gaussian beams. Keywords .Maxwell’s equations; decay estimates; trapped ray. 1 Introd...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010