Modification of the Pet-Membrane/Solution Interface: Effect on Electrical Parameters

نویسندگان

  • J. Benavente
  • R. de Lara
چکیده

Electrochemical characterization of a symmetric track-etched polyethylenthereftalate (PET) membrane in contact with KCl solutions at different concentrations was carried out by measuring impedance spectroscopy (IS) and membrane potential (MP), which allow the estimation of membrane electrical resistance and ion transport numbers, respectively. IS measurements permit us the characterization of membranes in “working conditions” (in contact with electrolyte solutions) and the determination of electrical parameters for the membrane and the membrane/solution interface (resistance, capacitance and Warburg impedance) by analyzing the impedance plots and using equivalent circuits as models. The non-reproducibility of membrane potential values for two series of measurements and the asymmetry of the impedance curves show the modification of the membrane/aqueous solution interface. This point was confirmed by the time evolution of the membrane system electrical resistance and the increase of nitrogen content obtained from X-ray photoelectron spectroscopy (XPS) analysis for dry and PET samples maintained in water for different periods of time, and the results indicate an increase in nitrogen content, which is attributed to bacterial presence on the membrane surfaces. These results seem to indicate modification of the PETmembrane/solution interface due to fouling and the possibility of its determination by electrical measurements.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Conductive Polythiophene Nanoparticles Deposition on Transparent PET Substrates: Effect of Modification with Hybrid Organic-inorganic Coating (RESEARCH NOTE)

In this work, Poly(ethyleneterephthalate) (PET) substrate was treated using KOH solution and was modified using hybrid O-I coating containing PCL )polycaprolactone( as organic phase and TEOS )tetraethoxysilane( as inorganic phase. The coating was prepared through a sol-gel process and applied on the surface by dip coater. Then, electrically conducting polythiophene (PTh) nanoparticles were depo...

متن کامل

Improvement of gas separation properties of polyurethane membrane using plasma grafting

In recent years, plasma treatments have given good results since they offer high technological efficiency with low waste generation. One of the most important characteristics of plasma methods is their action only on a thin surface layer, whereas the bulk of sample remains unchanged and the modified material keeps its chemical and mechanical properties. In this research, polyurethane membrane s...

متن کامل

Synthesis and Characterization of Cation Exchange PVA-g-PAA/PBI sulfone Membrane for the Electrolysis of Sodium Chloride

The reported work is on the preparation and characterization of polyvinyl alcohol -g- Polyacrylic acid (PVA-g-PAA)/ Polybenzimidazole sulfone (PBIs) cation exchange membrane used for the electro dialysis of sodium chloride solution. The polymer syrup has been prepared using the grafting method with the help of polyvinyl alcohol and polyacrylic acid in the presence of water solvent. The polymer ...

متن کامل

EFFECT OF OPERATING CONDITIONS ON THE DEHYDRATION OF TOLUENE BY PERVAPORATION USING A POLYVINYL ALCOHOL MEMBRANE

The effects of operating parameters such as feed temperature and permeate-side pressure on the performance of a commercial PVA membrane in the dehydration of toluene by a pervaporation (PV) membrane system is studied in the present work. The results obtained indicate that increasing temperature in the range of 40 to 70 °C and reducing permeate pressure in the range of 1 to 10 mmHg increase memb...

متن کامل

Variation of Immiscibility Gap in Polymer Solution Containing Alkane and Effects on Providing the Membrane

In oredr to reduce costs and save time for the membrane manufacturing process, it is necessary to improve the quality of membranes by modeling usage. In this study, Flory Huggins model was used to predict quaternary-system containing polyether sulfone, N-Methyl-2-pyrrolidone, water and used alkanes as an additive. Due to the solubility parameters and molar alkane volumes, the interaction parame...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2007