Sls Lattice Finalization and Magnet Girder Design
نویسندگان
چکیده
We describe the studies on dynamic aperture for the Swiss Light Source (SLS) 2.4 GeV storage ring including mini gap insertion devices, magnet misalignments and magnet multipole errors. We present a novel method for calculating the Touschek relevant effective lattice momentum acceptance and lifetime. Finally we describe the design of girders optimized for static and dynamic fatigue with high precision mounting of magnets on girders and a system of girder movers to be used for alignment of the girders around the ring.
منابع مشابه
Overall Design of Magnet Girder System for Heps-tf
HEPS-TF is the test facility of HEPS (High Energy Photon Source) of China. The magnet girders are used for supporting and positioning of the magnets. As the beam emittance is very low, the girder must has high adjusting precision and high stability. Besides, the girder should also be beam-based aligned. For these issues, two girder systems are designed. Both of them use cam mover mechanisms for...
متن کاملVibration of Magnet-girder Assembly
To improve the stability of the magnet-girder assemblies in the ESRF storage ring, vibration investigations have been carried out for in situ magnet-girder assemblies and a prototype. Characterisation tests were performed : operating response measurements, static stiffness measurements, modal testing. A finite element modelling (FEM) is being carried out for the prototype assembly. First result...
متن کاملA Mechanical Installation Prototype for the Ssrf Storage Ring
The engineering design of the mechanical system for SSRF storage ring was finished. The first group components in each system, such as the magnets, vacuum chambers, BPMs, girders and other hardware, were fabricated and tested, respectively. In order to check the overall design and the installation procedure, a lattice cell prototype was installed by using these components. Based on it, the rela...
متن کاملA Possible Design of the Linac-to-LEB Injection Girder for 1133 MeV H− Ions
We present a design of the girder to accommodate injection of 1133 MeV kinetic energy H− ions from the linac [1] into the LEB. This design is based on Colton and Thiessen’s design [2] for 600 MeV ions, and does not require a modification of the current [3] LEB lattice.
متن کاملOPTIMAL DESIGN OF NON-PRISMATIC REINFORCED CONCRETE BOX GIRDER BRIDGE: MINIMIZATION OF THE COST AND CO2 EMISSION
This paper presents a computational framework for optimal design of non-prismatic reinforced concrete box girder bridges. The variables include the geometry of the cross section, tapered length, concrete strength and reinforcement of box girders and slabs. These are obtained by the enhanced colliding bodies optimization algorithm to optimizing the cost and again CO2 emission. Loading and design...
متن کامل