The Nonlinear Dynamic Behavior Analysis and Research for Sheet Steel Stamping Forming Problems Based on Finite Element Method
نویسندگان
چکیده
A numerical framework for the simulation of sheet steel stamping forming is presented. The main problems, the equations of motion, the constitutive relation, the initial conditions, boundary conditions and contact conditions, are presented in detail. Based on this, the finite element model is established and solved for exploring the changes in laws of stress, strain and so on. The information on stress, strain and load displacement is obtained at different deformation stages. The numerical results show that the finite element algorithm can effectively simulate the deformation process of sheet steel which helps to explain that the numerical framework is feasible for sheet steel stamping forming problems.
منابع مشابه
Analysis of deep drawing process to predict the forming severity considering inverse finite element and extended strain-based forming limit diagram
An enhanced unfolding Inverse Finite Element Method (IFEM) has been used together with an extended strain-based forming limit diagram (EFLD) to develop a fast and reliable approach to predict the feasibility of the deep drawing process of a part and determining where the failure or defects can occur. In the developed unfolding IFEM, the meshed part is properly fold out on the flat sheet and tre...
متن کاملInvestigation of Nonlinear Behavior of Composite Bracing Structures with Concrete Columns and Steel Beams (RCS) Applying Finite Element Method
The composite structural system (RCS) is a new type of moment frame, which is including a combination of concrete columns (RC) and steel beams (S). These structural systems have the advantages of both concrete and steel frames [1]. In previous research on composite structures, there are some studies regarding RCS composite conections, but there is no investigation about seismic resisting system...
متن کاملInvestigation on Forming of Titanium Bipolar Plates Using Micro-stamping Process
Micro-stamping process is one of the most cost-effective methods to manufacture metallic bipolar plates (BPPs). This research investigates the forming of titanium thin sheet as a potential candidate for BPPs in proton exchange membrane fuel cell (PEMFC). In this regard, the process was first simulated using finite element (FE) code Abaqus. Afterward, experimental tests were implemented and the ...
متن کاملDevelopment of a Predictive Finite Element Model For Investigation of Phases Behavior After Cold Rolling Process
One of the surface defects that arise in sheet metal working is when the part removes from the die. Since there are no external forces to make this defect, the origin of such fail is known as residual stress. Residual stress can develop in sheet metal forming due to non uniform deformation. In this paper, the workpiece is carbon steel with different volume fractions and arrangement of ferrite ...
متن کاملThe Study of Deep Drawing of Brass-steel Laminated Sheet Composite Using Taguchi Method
Deep drawing process is one of the most applicable methods in producing industrial parts. In this process, the initial blank deforms to final product using a rigid punch and die. In this investigation, the effect of deep drawing process parameters of brass/steel laminated sheet composites on required forming force has been investigated. The process simulated using finite element method (FEM) an...
متن کامل