A 1.5V,100MS/s,12-bit Current-Mode CMOSS ample-and-Hold Circuit
نویسندگان
چکیده
A high-linearity and high-speed current-mode sampleand-hold circuit is designed and simulated using a 0.25μm CMOS technology. This circuit design is based on low voltage and it utilizes a fully differential circuit. Due to the use of only two switches the switch related noise has been reduced. Signal dependent -error is completely eliminated by a new zero voltage switching technique. The circuit has a linearity error equal to ±0.05μa, i.e. 12-bit accuracy with a ±160 μa differential output input signal frequency of 5MHZ, and sampling frequency of 100 MHZ. Third harmonic is equal to –78dB. Keywords—Zero-voltage-technique, MOS-resistor, OTA, Feedback-resistor.
منابع مشابه
Microsoft Word - CONTENTS-DECEMBER06
A high-linearity and high-speed current-mode sampleand-hold circuit is designed and simulated using a 0.25μm CMOS technology. This circuit design is based on low voltage and it utilizes a fully differential circuit. Due to the use of only two switches the switch related noise has been reduced. Signal dependent -error is completely eliminated by a new zero voltage switching technique. The circui...
متن کاملA L6V IO-bit 2OMHz Current-mode Sample and Hold Circuit
A current mode sample and hold circuit has been designed to examine if high-precision current processing is possible simultaneously with a circu it to which current mode and switched-current circuits are applied and which operates at high-speed and with low supply voltage. The results are 1 O-bit accuracy, a 20MHz clock, and a 2 V supply voltage. Clock feedthroug h which degrades the precision ...
متن کاملA current-mode, 3 V, 20 MHz, 9-bit equivalent CMOS sample-and-hold circuit
| A new current-mode, low-power, lowvoltage and high-speed CMOS sample-and-hold circuit has been designed and fabricated. A new currentmode di erential switching scheme has been adopted to eliminate errors caused by feedthrough injection from the sample switches. The experimental result yields 9-bit resolution in 9mW power dissipation, in a 20MHz clock frequency from a 3V power supply.
متن کاملA Current-Mode Single-Resistance-Controlled Oscillator Employing VDCC and All Grounded Passive Elements
Realization of a novel single-resistance-controlled oscillator, employing an active element and all grounded passive elements, is the purpose of this manuscript. With requirements for completing the design being only a single Voltage Differencing Current Conveyor and four grounded passive components, it is also a preferable choice for integrated circuit implementation. The designed circuit has ...
متن کاملRealization of Electronically Controllable Current-mode Square-rooting Circuit Based on MO-CFTA
This article proposes a current-mode square-rooting circuit using current follower transconductance amplifier (CTFA). The amplitude of the output current can be electronically controlled via input bias current with wide input dynamic range. The proposed circuit consists of only single CFTA. Without any matching conditions and external passive elements, the circuit is then appropriate for an IC ...
متن کامل