Computer simulations of interactions between ultrafine alumina particles produced by an arc discharge
نویسندگان
چکیده
We wrote two computer programs, 3D and BUMP, to interpret transmission electron microscope (TEM) micrographs made during a study of the initial stage sintering of ultrafine alumina particles (UFP’s, 20–50 nm in diameter). The first simulated the 3D geometric relationships of particles, from which we concluded that surface diffusion was the predominant sintering mechanism because no shrinkage occurred. BUMP simulated random contact of two particles and showed that the particle chains that formed before sintering were not formed purely by chance. Instead the particles experienced a rearrangement process (rotation and sliding) which reduced the total surface energy.
منابع مشابه
Secondary Particles Produced by Hadron Therapy
Introduction Use of hadron therapy as an advanced radiotherapy technique is increasing. In this method, secondary particles are produced through primary beam interactions with the beam-transport system and the patient’s body. In this study, Monte Carlo simulations were employed to determine the dose of produced secondary particles, particularly neutrons during treatment. Materials and Methods I...
متن کاملThe Synthesis of Carbon Nano Tubes by Arc Discharge Method in Liquid media
In this investigation a simplified arc discharge apparatus was used to synthesize mullti-wall carbon nanotubes. Because of not requiring vacuum equipment, heat exchange system, active or inert gases, this method is found to be cheaper and simpler than traditional arc discharge in gas environment. Using this method, CNTs are produced by performing an arc discharge between two graphite electrodes...
متن کاملUltrafine particles emitted by flame and electric arc guns for thermal spraying of metals.
The ultrafine aerosol emitted by thermal spraying of metals using flame and electric arc processes has been characterized in terms of particle size distribution and emission rates based on both particle number and mass. Thermal spraying of Zn, Zn/Al, and Al was studied. Measurements taken using an electrical low pressure impactor and a condensation nucleus counter reveal an aerosol made up of v...
متن کاملFabrication of Biodegradable PCL Particles as well as PA66 Nanofibers via Air-Sealed Centrifuge Electrospinning (ASCES)
This study presents a method for fabrication of ultrafine polymeric nanofibers as well as nano/micro particles utilizing centrifugal and electrostatic forces simultaneously. To reduce the diameter and variety of nanofibers produced from solid state polymerized PA66, a unique electrocentrifuge spinning device was utilized with a rotating nozzle and collector, while the fabrication process (spinn...
متن کاملEffect of Silica Content on Support-Iridium Active Phase Interactions on the Nanocatalyst Activity
To discuss the potential role of the support for iridium catalyst, we have proceeded to prepare a series of supported catalysts with the same active phase content, but different silica content, to elucidate the changes in surface structure and the reaction process of hydrous hydrazine decomposition on catalyst. The obtained iridium catalysts contained 20 wt% of nanoparticles dispersed on spheri...
متن کامل