730. The rings with molecular current as the model of the passive magnetic bearing
نویسنده
چکیده
There will be presented a model of a passive magnetic bearing. The model uses the ring with molecular current as a source of external magnetic field (the unmovable magnet mounts in a case of machine). The next ring with molecular current moves in external field generated by unmovable ring (the magnet connects with the shaft of machine). The density of magnetic field is obtained from the Biota-Savarta law and the force is estimated from the Lorentz law. Moreover, there will be estimated the damping factor proportional to the speed of the movable magnet. The model can be used to design the radial passive magnetic bearings.
منابع مشابه
Study of Permanent Magnet Bearings and their Stiffness
A typical passive magnetic bearing has been modeled and analyzed for its performance characteristics. The magnetic bearing studied in this work comprised of a Shaft, inner magnets sleeved over the shaft, and outer magnetic rings. A detailed analysis has been perform on the force exerted by a permanent magnet on the shaft nurture to restore the shaft to its equilibrium position when an eccentric...
متن کاملStudying the effects of pH and molecular charge on the passive and iontophoretic permeation of L-phenylalanine through cellulose acetate membrane
Iontophoresis is one of the skin permeation enhancement methods involving the transport of drugs through the skin under the effect of electrical current. The effect of molecular charge on the iontophoretic permeation of drugs has not been completely understood yet. Therefore the effect of passive and iontophoretic permeation of L-phenylalanine at pH 3.6 (positive charge) and pH 8 (negative ch...
متن کاملMagnetic fluid lubrication of porous pivoted slider bearing with slip and squeeze velocity
In this paper the problem on “Magnetic fluid lubrication of porous-pivoted slider bearing with slip velocity by N Ahmad et.al.[7]” has been recapitulated using Jenkin’s model [4] with the additional effect of squeeze velocity of the above plate. It is found that while discussing the above problem, [7] has stated but ignored the term , where +, in their study (Refer equation(2.2)). This paper re...
متن کاملUsing an Appropriate Controller for Independent Current Control for Motoring of Force Windings of Bearing less Induction Motor
A bearingless induction machine has combined characteristics of induction motor and magnetic bearings. Therefore, the advantages are small size and low-cost. In the magnetic suspension of the bearingless motors, suspension forces are generated based on the feedback signals of displacement sensors detecting the movement of the rotor shaft. The suspension forces are generated taking an advantage ...
متن کاملUse of Ansoft to Model a Slice Magnetic Bearing
Maxwell 3D of Ansoft software were used for this study. Ansoft’s solutions are based on a more general program using Maxwell’s equations. A simple analysis has been done for calculating the magnetic force interacted between two magnets of similar poles facing each other. The modeling in Anosoft has been described.
متن کامل