Formation and kinetics study of cuprous oxide nanodots on LaAlO3 (0 0 1)
نویسندگان
چکیده
Cu2O nanodots have been grown on LaAlO3 (0 0 1) substrates using metalorganic chemical vapor deposition. X-ray diffraction reveals that the nanodots grow epitaxially on the substrate. The dots are hut-shaped islands with {1 1 1} side facets. Evolution of the nanodot shape, density, and size during growth has been analyzed by scanning electron microscopy and atomic force microscopy. It is shown that Ostwald ripening plays an important role in nanodot growth. 2004 Elsevier B.V. All rights reserved.
منابع مشابه
Synthesis of Cuprous Oxide by Thermal Treatment in Liquid Paraffin
Cu2O nanoparticles were synthesized by thermal treatment in liquid paraffin without any inert gas protection using nano structures of Schiff base copper (II) complex (1) as precursor. Liquid paraffin was used as solvent and reductant. Span 80 was applied to control the morphology of cuprous oxide nanoparticles. The nano structure of the complex was characterized by X-ray diffraction measurement...
متن کاملتولید اکسید مس به روش الکتـروشیمیـایی
The electrochemical process of cuprous oxide production is by the anodic dissolution of copper in an alkaline concentrated sodium chloride solution. The initial chloride in the electrolyte cell provides a condition for the formation of cuprous chlorocomplex anions. In the end,the cuprous oxide is formed through the anions hydrolysis by the hydroxyl ions, which are generated in the cathodic reac...
متن کاملAtomic-layer-deposited LaAlO3/SrTiO3 all oxide field-effect transistors
We have demonstrated well-behaved accumulation-mode all oxide NMOSFETs with amorphous atomic-layer-deposited (ALD) LaAlO3 gate dielectric stacks on crystalline SrTiO3 substrates. A maximum drain current exceeding 10 mA/mm has been obtained on a 3.75μm-gate-length device, proving a very conductive channel can be formed at the oxide-oxide interface. Four different gate dielectric stacks, which ar...
متن کاملElectrical properties of metal–oxide–silicon structures with LaAlO3 as gate oxide
In this paper, electrical investigations performed on complex metal–oxide–semiconductor (MOS) structures with amorphous LaAlO3 deposited as gate oxide on a rapid thermal processed SiO2 buffer layer are presented. Current–voltage (I–V) measurements at different temperatures and high frequency room-temperature capacitance–voltage (C–V) measurements indicate the presence of a non-equilibrium state...
متن کاملScanned Probe Oxidation onp-GaAs(100) Surface with an Atomic Force Microscopy
Locally anodic oxidation has been performed to fabricate the nanoscale oxide structures on p-GaAs(100) surface, by using an atomic force microscopy (AFM) with the conventional and carbon nanotube (CNT)-attached probes. The results can be utilized to fabricate the oxide nanodots under ambient conditions in noncontact mode. To investigate the conversion of GaAs to oxides, micro-Auger analysis was...
متن کامل