Mixtures of latex particles and the surfactant of opposite charge used as interface stabilizers--influence of particle contact angle, zeta potential, flocculation and shear energy.
نویسندگان
چکیده
We investigate the stabilization of air-water interfaces by mixtures of negatively charged latex particles (sulfate polystyrene) and cationic surfactants (alkyl trimethylammonium bromides). First we report results concerning the binding of surfactant molecules to the latex particles. As the surfactant concentration increases, the charge of the particles reverses, from negative to positive, because CnTAB first binds electrostatically to the latex particles and then through hydrophobic interaction with the monolayer already adsorbed on the particles as well as directly with the hydrophobic surface of the latex. Over a large range of surfactant concentrations around the charge inversion, a strong flocculation is observed and 100 μm large aggregates form in the suspension. Unlike previous studies published on mixtures of inorganic particles with oppositely charged surfactants, we show that we can vary the sign of the zeta potential of the particles without changing the contact angle of the particles over a large range of surfactant concentrations. Indeed, the latex particles that we study are more hydrophobic than inorganic particles, hence adding moderate concentrations of the surfactant results in a weak variation of the contact angle while the charge of the particles can be reversed. This enables decoupling of the effect of zeta potential and contact angle on the interfacial properties of the mixtures. Our study shows that the contact angle and the charge of the particles are not sufficient parameters to control the foam properties, and the key-parameters are the flocculation state and the shear energy applied to produce the foam. Indeed, flocculated samples, whatever the sign of the zeta potential, enable production of a stable armour at the interface. The large aggregates do not adsorb spontaneously at the interface because of their large size, however when a large shear energy is used to produce the foam very stable foam is obtained, where particles are trapped at interfaces. We suggest that the large aggregates may be broken during shear and may reform at the interface to form a solid armour. A simple calculation taking into account the adsorption dynamics of the aggregates as a function of their size is consistent with this hypothesis.
منابع مشابه
Insight into Zeta Potential Measurements in Biopolymer Film Preparation
Microand nano-particle charge is one of the main factors determining the physical stability of both emulsions and suspensions and can be quantified by measuring their so called “zeta potential”. When all the particles have a large either negative or positive zeta potential value, they will repel each other and, as a consequence, the suspension becomes stable. By contrast, whether the zeta poten...
متن کاملInvestigation of the effect of different percentages of material on the microstructure and morphology of montmorillonite nanoparticles
In this research, Montmorillonite clay nanoparticles were produced using mechanical methods and the effect of different percentages of tetra n-butyl ammonium chloride (TNBAC) as a surfactant and butyl ammonium chloride as a modifier (TNBAC) was performed. The microstructural and morphological properties of montmorillonite clay nanoparticles in the presence and absence of surfactant as well as s...
متن کاملEffect of charge balance and dosage of polyelectrolyte complexes on the shear resistance of mineral floc strength and reversibility.
We evaluated the effect of polyelectrolyte complexes (PEC) with varying balance of charges on the flocculation of precipitated calcium carbonate (PCC) particles. PECs composed of polyacrylamides carrying opposite charges (A-PAM and C-PAM) were investigated in terms of PCC floc shear resistance and re-flocculation effects. Light transmission was used in real time to monitor the dynamics of flocc...
متن کاملElectrokinetic behavior and colloidal stability of polystyrene latex coated with ionic surfactants.
This work is focused on analyzing the electrokinetic behavior and colloidal stability of latex dispersions having different amounts of adsorbed ionic surfactants. The effects of the surface charge sign and value, and the type of ionic surfactant were examined. The analysis of the electrophoretic mobility (mu(e)) versus the electrolyte concentration up to really high amounts of salt, much higher...
متن کاملA Numerical Simulation Study on the Kinetics of Asphaltene Particle Flocculation in a Two-dimensional Shear Flow
In the current study, the kinetics of asphaltene particle flocculation is investigated under a shear flow through numerical simulation. The discrete element method (DEM) is coupled with computational fluid dynamics (CFD) to model the agglomeration and fragmentation processes. In addition, a coalescence model is proposed to consider the attachment of colliding particles. The changes in mean asph...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Soft matter
دوره 10 36 شماره
صفحات -
تاریخ انتشار 2014