Directly diode-pumped millijoule subpicosecond Yb:glass regenerative amplifier.
نویسندگان
چکیده
An Yb:glass regenerative amplifier directly side pumped by four 20-W diodes is demonstrated. By use of a novel pumping scheme and introduction of cylindrical optics into the cavity, a free-running average output power as great as 4 W with a TEM(00) -like mode was achieved from the bare cavity, with a 0.56 pump duty cycle. When the regenerative amplifier injected, 1-mJ 200-fs FWHM pulses were obtained following compression by use of 2-ms pump pulses and up to a 150-Hz repetition rate.
منابع مشابه
Directly diode-pumped Yb3+:SrY4(SiO4)3O regenerative amplifier.
We report a regenerative amplifier based on an Yb-doped apatite crystal: Yb3+:SrY4(SiO4)3O (Yb:SYS). We obtained 420-fs pulses at a central wavelength of 1066 nm with an energy of 100 microJ at 300 Hz after compression. To the best of our knowledge, this system is the first regenerative amplifier based on an Yb:SYS crystal and provides duration among the shortest ones generated by a directly di...
متن کاملNd:glass diode-pumped regenerative amplifier, multimillijoule short-pulse chirped-pulse-amplifier laser.
We have built a diode-pumped Nd:glass regenerative amplifier that is able to produce energies up to 20 mJ within a 470-fs pulse duration at a 1-Hz repetition rate. We obtained this amplifier by using specific intracavity components such as a phase mirror and a birefringent filter to generate a large spatial mode and a large spectral width.
متن کامل2.5 mJ, sub-nanosecond pulses from single-crystal fiber amplifier in a kHz MOPA system
A Master Oscillator Power Amplifier configuration using a Nd:YAG single-crystal fiber to amplify a passively Q-switched microlaser is presented. We achieved the amplification of 80 μJ, sub-nanosecond pulses to the multi-millijoule regime. OCIS codes: (140.3580) Lasers, solid-state; (140.3480) Lasers, diode-pumped; (140.3530) Lasers, neodymium; (140.3380) Laser materials; (060.2290) Fiber materi...
متن کاملTwenty-watt average output power, picosecond thin-rod Yb:YAG regenerative chirped pulse amplifier with 200 μJ pulse energy
A high-average power, laser-diode-pumped, picosecond-pulse regenerative chirped pulse amplifier was developed by using the thin-rod Yb:YAG laser architecture. An average output power of 20 W was achieved at a repetition rate of 100 kHz with an output pulse width of 2 ps. 2008 Optical Society of America OCIS codes: (140.3280) Lasers, amplifiers, (140.3615) Lasers, ytterbium, (140.3480) Lasers, ...
متن کاملArgon-ion-pumped and diode-pumped all-solid-state femtosecond Cr:LiSrAlF(6) regenerative amplifiers.
A tunable femtosecond solid-state amplifier system that uses only 3 W of 488-nm argon-ion pump power has been demonstrated to deliver microjoule pulses at repetition rates up to 20 kHz, with a maximum pulse energy of 14 mu;J obtained at 5 kHz. An all-solid-state, tunable, diode-pumped Cr:LiSrAlF(6) regenerative amplifier has been demonstrated, for the first time to our knowledge, that amplifies...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics letters
دوره 24 13 شماره
صفحات -
تاریخ انتشار 1999