The Experience with SiC MOSFET and Buck Converter Snubber Design
نویسنده
چکیده
The newest semiconductor devices on the market are MOSFET transistors based on the silicon carbide – SiC. This material has exclusive features thanks to which it becomes a better switch than Si – silicon semiconductor switch. There are some special features that need to be understood to enable the device’s use to its full potential. The advantages and differences of SiC MOSFETs in comparison with Si IGBT transistors have been described in first part of this article. Second part describes driver for SiC MOSFET transistor and last part of article represents SiC MOSFET in the application of buck converter (step-down) and design of simple RC snubber. Keywords—SiC, Si, MOSFET, IGBT, SBD, RC snubber.
منابع مشابه
Method to Suppress the Parasitic Resonance Using Parallel Resistor and Inductor Combination To Reduce Broadband Noise from DC/DC Converter
Synchronous buck converters generate broadband noise typically in 50 – 300 MHz range due to the parasitic LC resonance in the switching loop which consists of input decoupling capacitors, high-side MOSFET and low-side MOSFET. Typically, this parasitic resonance is attenuated using an R-C snubber placed parallel to the low-side MOSFET. However, selection of the R and C value of the snubber is no...
متن کاملA Buck-Boost Converter; Design, Analysis and Implementation Suggested for Renewable Energy Systems
This work introduces a new non-isolated buck-boost DC-DC converter. Interleaved configuration of the suggested structure increases the voltage conversion ratio. The voltage rate of the suggested converter can be stepped-up and stepped down for lower values of duty-cycle, which causes to decrease in the conduction losses of the system. The voltage conversion ratio of the recommended structure is...
متن کاملA passive lossless snubber cell for nonisolated PWM DC/DC converters
A passive lossless snubber cell is proposed to improve the turn-on and turnoff transients of the MOSFET’s in nonisolated pulsewidth modulated (PWM) dc/dc converters. Switching losses and EMI noise are reduced by restricting di=dt of the reverse-recovery current and dv=dt of the drain–source voltage. The MOSFET operates at zero-voltage-switching (ZVS) turnoff and near zero-current-switching (ZCS...
متن کاملA New, Soft-switched Boost Converter with Isolated Active Snubber
A boost converter which employs an isolated active snubber to reduce the losses caused by the reverserecovery characteristic of the boost rectifier and the turnon discharge loss of the output capacitance of the boost switch is described. The proposed isolated active snubber consists of a coupled inductor, clamp capacitor, and ground-referenced N-type MOSFET. The performance of the proposed conv...
متن کاملReduction of Switching Losses for a DC-DC Converter using RCD Clamp Circuit
A snubber for a buck-boost converter is presented. The proposed snubber uses a resistor, inductor and capacitor. This circuit is capable of resetting the transformer, as well as eliminating leakage inductance voltage spike across the power switch. The proposed snubber eliminates the losses due to switching by freewheeling action through the diode.
متن کامل