Receiver Jitter Tracking Characteristics in High-Speed Source Synchronous Links
نویسندگان
چکیده
High-speed links which employ source synchronous clocking architectures have the ability to track correlated jitter between clock and data channels up to high frequencies. However, system timing margins are degraded by channel skew between clock and data signals and high-frequency loss. This paper describes how these key channel effects impact the jitter performance and influence the clocking architecture of high-speed source synchronous links. Tradeoffs in complexity and jitter tracking performance of common per-channel de-skew circuits are discussed, along with how band-pass filtering can be leveraged to provide additional jitter filtering at the receiver. Jitter tolerance analysis for a 10Gb/s system shows that a near all-pass delay-locked loop (DLL) and phase-interpolator(PI-) based de-skew performs best under low skew conditions, while, at high skew, architectures which leverage band-pass clock filtering or a phase-locked loop (PLL) for increased jitter filtering are more suitable. De-skew based on injection-locked oscillators (ILOs) offer a reduced complexity design and competitive jitter tolerance over a wide skew range.
منابع مشابه
Modeling and Mitigation of Jitter in Multi-Gbps Source-Synchronous I/O Links
Jitter significantly limits the maximum achievable data rates (MADR) over high-speed source-synchronous I/O links. In this paper, we present a simple model that comprehends transmitter and receiver jitter in a source-synchronous I/O link. We show that the channel can have a significant impact on transmit jitter at high data rates, resulting in 1.1X3.8X jitter amplification for typical cases. We...
متن کاملOn-Chip Measurement and Compensation of Timing Imbalances in High-Speed Serial NoC Links
This paper presents techniques for measurement and compensation of timing variations in clock and data channels of source-synchronous high-speed serial network-on-chip (NoC) links. Timing mismatch measurements are performed by means of asynchronous sub-sampling. This allows the use of low quality sampling clocks to reduce test hardware overhead for integration into complex MPSoCs (Multiprocesso...
متن کاملAdaptive Voltage-based Control of Direct-drive Robots Driven by Permanent Magnet Synchronous Motors
Tracking control of the direct-drive robot manipulators in high-speed is a challenging problem. The Coriolis and centrifugal torques become dominant in the high-speed motion control. The dynamical model of the robotic system including the robot manipulator and actuators is highly nonlinear, heavily coupled, uncertain and computationally extensive in non-companion form. In order to overcome thes...
متن کاملA Fuzzy Controlled PWM Current Source Inverter for Wind Energy Conversion System
In recent years, there has been a fast growth in wind energy conversion system (WECS). There are two general types of wind turbines in WECS: fixed speed wind turbines and varying speed wind turbines.Permanent magnet synchronous generator (PMSG) is one of the most attractive generators for the varying speed turbine WECS.In this paper, a fuzzy controller is proposed to control the current source ...
متن کاملAccurate Prediction of Jitter Tolerance in High-Speed Serial Links
This paper presents a novel mixed-signal verification methodology for jitter tolerance in highspeed serial-link receiver designs. The predictive approach includes identifying the jitter sources at the receiver input, generating the artificial jitter to add on input data and clock, and investigating the jitter sensitivities inside the receiver with bit error indicator. Both an artificial jitter ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- J. Electrical and Computer Engineering
دوره 2011 شماره
صفحات -
تاریخ انتشار 2011