On the spectrum-determined growth condition of a vibration cable with a tip mass

نویسندگان

  • Bao-Zhu Guo
  • Cheng-Zhong Xu
چکیده

In this correspondence, we show that the spectrum-determined growth condition holds for the closed-loop system of a vibration cable with a tip mass and linear boundary feedback control. The optimal decay rate of the energy for a case left unsolved in the [1] is determined, and the asymptotic expansion of the associated semigroup is obtained. As a consequence of the approach, we show, in a different point of view, the lack of uniform exponential stability of the system with only boundary velocity feedback control.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Nonlocal First Order Shear Deformation Theory for Vibration Analysis of Size Dependent Functionally Graded Nano beam with Attached Tip Mass: an Exact Solution

In this article, transverse vibration of a cantilever nano- beam with functionally graded materials and carrying a concentrated mass at the free end is studied. Material properties of FG beam are supposed to vary through thickness direction of the constituents according to power-law distribution (P-FGM). The small scale effect is taken into consideration based on nonlocal elasticity theory of E...

متن کامل

Nonlinear Vibration Analysis of the Composite Cable using Perturbation Method and the Green-Lagrangian Nonlinear Strain

In this study, nonlinear vibration of a composite cable is investigated by considering nonlinear stress-strain relations. The composite cable is composed of an aluminum wire as reinforcement and a rubber coating as matrix. The nonlinear governing equations of motion are derived about to an initial curve and based on the fundamentals of continuum mechanics and the nonlinear Green-Lagrangian stra...

متن کامل

A new method for drawing the capacity spectrum for seismic analysis and structural rehabilitation

A review of previous studies shows that there are two general views on how to determine demand in structures through incremental nonlinear static analysis. In the first view, multi-modal methods are used to determine demand in structures. In this view, the applied load pattern is applied to the structure according to the shape of each vibration mode, assuming that the structure deformation foll...

متن کامل

Extended Finite Element Method for Statics and Vibration Analyses on Cracked Bars and Beams

In this paper, the extended finite element method (XFEM) is employed to investigate the statics and vibration problems of cracked isotropic bars and beams. Three kinds of elements namely the standard, the blended and the enriched elements are utilized to discretize the structure and model cracks. Two techniques referred as the increase of the number of Gauss integration points and the rectangle...

متن کامل

Simulation-based Vibration Sensor Placement for Centrifugal Pump Impeller Fault Detection

In this paper, a simulation-based method is proposed for optimal placement of vibration sensors for the purpose of fault detection in a centrifugal pump. The centrifugal pump is modeled to investigate the effect of vane tip fault on fluid flow patterns numerically. Pressure pulsations are investigated at different locations at the inner surface of the pump before and after the presence of the f...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • IEEE Trans. Automat. Contr.

دوره 45  شماره 

صفحات  -

تاریخ انتشار 2000