Numerical modeling of claw-poles alternator
نویسندگان
چکیده
The paper present a program of modeling of a claw-poles alternator with the program Magnet 6.11, which after the input data of machine realize the geometrical model for numerical analyzes. After analysis, the program can be changed automatically and made a new model, that can be analyzed automatically and not being necessarily construction the model with the drawing program each time its necessary.
منابع مشابه
Study of Electromagnetic Field in Claw-poles Alternator
The paper presents the tridimensional analysis of electromagnetic field of an claw poles alternator, in whose construction has been used non-magnetic material, such aluminum, that form the rings in the rotor’s structure. This structure aims to establish lower levels of saturation in the claw-pole of Lundell alternator. Reducing the level of saturation in the rotor, lead to reduction of the loss...
متن کاملEmbedded Simple Excited Automotive Alternator Modeling using Magnetic Equivalent Circuits
Received Jun 12, 2016 Revised Nov 28, 2016 Accepted Dec 12, 2016 This paper presents the modeling by Magnetic Equivalent Circuit model (MEC) of a Simple Excited Automotive Alternator (SE2A) where DCexcitation winding is transferred from rotor side to statorone rather than in conventional automotive claw pole alternators, to overcome the disadvantages of the ring-brush system. Following the reso...
متن کاملWeC2-1 : Foil Field Lundell Alternator with Rotating Power Electronics
The power requirements of automotive alternators are increasing significantly due to the introduction of new vehicle electrical loads. We aim to improve alternator power density with the use of a foil field winding in the Lundell or claw-pole alternator. Foil field windings are shown to provide higher conductor packing factors than conventional wire wound fields (e.g. 73% as opposed to 64% for ...
متن کاملComparison of different electrical machines for Belt Driven Alternator Starters
In this thesis focus is on the electromagnetic design of a synchronous machine suited for a belt driven alternator and starter (BAS) in a micro hybridisation of a mid size passenger car. The BAS needs to provide a high cranking torque to start the combustion engine, especially in a cool condition where the requirements is highest. Beside the high cranking torque is it desirable to have a high p...
متن کاملControl Oriented Modeling and System Identification for a Generator Set
A diesel generator set (genset) refers to a diesel engine powered electrical alternator. Controls are needed to regulate the electrical output at the nominal voltage (120V RMS) and frequency (60Hz) despite variation in the electrical loads. In this paper, a system model for the genset is developed. A grey-box system model that considers known physical dependence and empirical identification of ...
متن کامل