Combined Calibration Method and its Realization for Direction Finding Antenna Systems with Patch Antennas
نویسندگان
چکیده
A novel radio channel compensation method aiming to give optimal calibration for microstrip antenna array systems is presented in this paper, realized for an actual DOA measurement antenna system using microstrip antennas to sample the electromagnetic field, operating at 4.5GHz. This new approach considers mismatch between antennas and channel RF ports, channel transmission inequalities, and also decreases the effects of multipath propagation components of calibration reference signals by placing the calibration reference signal feeding network on the microstrip antenna array bearer, directly beside the antenna patches. It is combined with orthogonal spread spectrum calibration signal utility for continuous uninterrupted measurements. The spread spectrum calibration signal is orthogonal to the continuous wave (CW) signal to be measured, therefore, the 2 signals can be separated in the receiver, enabling them to be present simultaneously. DOA measurement results are shown, measured with the realized integrated microstrip patch antenna array with calibration network hardware.
منابع مشابه
Determination of Resonance Frequency of Dominant and Higher Order Modes in Thin and Thick Circular Microstrip Patch Antennas with Superstrate by MWM (RESEARCH NOTE)
An accurate model named as the Modified Wolff Model (MWM) is presented as an efficient CAD tool for determination of resonant frequency of the dominant and higher order modes under the multi-layer condition in thin and thick circular microstrip patch antennas. The effects of dielectric cover on the resonant frequency obtained from MWM have been compared against the result of theoretical method ...
متن کاملConical Conformal Antenna Design using the CPM Method for MIMO Systems
Abstract- In this article, the design of conformal antennas has been discussed using the characteristic modes (CM) method. For this purpose, the vector wave function(VWF) has been utilized to achieve a two-dimensional mapping of the conformal antenna. In designing and analyzing of cone-shaped antennas applicable for multi-input multi-output (MIMO) systems, the most important goal is to achieve ...
متن کاملAntenna Miniaturization Using Fractals (RESEARCH NOTE)
Antenna Miniaturization Using Fractals Richa Garg, AP ECE Deptt., [email protected], J.C.D.C.O.E., Sirsa ABSTRACTThe use of fractal geometry in designing antenna has been a resent topic of interest. Fractal shape has their own unique characteristics that the improved antenna performance can be achieved without degrading the antenna properties. Modern telecommunication system requires antenn...
متن کاملComparative Investigation of Half-mode SIW Cavity and Microstrip Hybrid Antenna Using Different Patch Shapes
A set of hybrid microstrip patch and semi-circular cavity antennas is introduced. The semi-circular cavity is implemented using Half-mode Substrate Integrated Waveguide (HMSIW) technique. Different shapes of patch include rectangular, semi-circular and equilateral triangular are excited using proximity effect by the circular SIW cavity at its TM010 mode of operation. The whole structures have b...
متن کاملImpedance bandwidth optimization of double slots circular patch antenna using genetic algorithm and the Interface Fuzzy Logic
A modified circular patch antenna design has been proposed in this paper, the bandwidth of this antenna is optimized using the genetic algorithm (GA) based on fuzzy decision-making. This design is simulated with HP HFSS Program that based on finite element method. This method is employed for analysis at the frequency band of 1.4 GHz- 2.6 GHz. It gives good impedance bandwidth of the order o...
متن کامل