Two-dimensional model of heat transfer in circulating fluidized beds. Part II: Heat transfer in a high density CFB and sensitivity analysis
نویسندگان
چکیده
Experiments were conducted in a 76 mm diameter jacketed riser of a dual-loop high-density circulating fluidized bed facility with FCC particles of 65 lm Sauter mean diameter as bed material. The suspension temperature and the average and local suspension-to-wall heat transfer coefficients were measured. After superimposing the heat transfer results when the suspension near the wall is allowed to move intermittently downwards and upwards, the model proposed in Part I predicts the experimental results well. The model is used to investigate the effects of various operating parameters on the heat transfer process. 2003 Elsevier Science Ltd. All rights reserved.
منابع مشابه
Evaluation of Eulerian Two-Fluid Numerical Method for the Simulation of Heat Transfer in Fluidized Beds
Accurate modeling of fluidization and heat transfer phenomena in gas-solid fluidized beds is not solely dependent on the particular selected numerical model and involved algorithms. In fact, choosing the right model for each specific operating condition, the correct implementation of each model, and the right choice of parameters and boundary conditions, determine the accuracy of the results i...
متن کاملBed Voidage and Heat Transfer in Non-Newtonian Liquid-Solid Fluidized Bed
The presence of particles in liquid-solid fluidized beds enhances the bed heat transfer, because the movement of the particles leads to an increased turbulence in the system. Moreover, the violent movement of the particles has a positive effect on fouling of the heat transfer surface. The aim of this investigation was to perform systematic measurements of bed voidage and heat transfer coeff...
متن کاملHeat Transfer of Liquid/ Solid Fluidized Beds for Newtonian and Non-Newtonian Fluids
The excellent performance of fluidized bed heat exchangers is due to the interaction between particles and heat transfer surface and to the mixing effects in the viscous sublayer. In this paper, the results of experimental investigations on heat transfer for a wide range of Newtonian and non-Newtonian (shear-thinning power law) fluids are presented. New design equations have been developed ...
متن کاملImproving Three Phase Modeling of Fluidized Bed Dryer
Heat transfer phenomena in batch fluidized bed dryer have been studied and analyzed using three phase model including solid phase, interstitial gas phase and bubble phase based on Rizzi model. New correlations of heat transfer coefficient to surrounding and convection heat transfer coefficient between solid and interstitial gas are being proposed. In addition, some modifications have been d...
متن کاملComputational Fluid Dynamic- Two Fluid Model Study of Gas-Solid Heat Transfer in a Riser with Various Inclination Angles
A two fluid model (TFM) was used to study gas-solid heat transfer in a riser with different inclination angles. A two dimensional pipe with 5.8 cm internal diameter and 5 meter length was chosen. Effect of bed angle and solid particles feed rate were studied on the heat transfer behavior of gas and solid particles. Obtained results from simulation are compared with the experimental data in the...
متن کامل