Spontaneous dispersion of particles on liquid surfaces.
نویسندگان
چکیده
When small particles (e.g., flour, pollen, etc.) come in contact with a liquid surface, they immediately disperse. The dispersion can occur so quickly that it appears explosive, especially for small particles on the surface of mobile liquids like water. This explosive dispersion is the consequence of capillary force pulling particles into the interface causing them to accelerate to a relatively large velocity. The maximum velocity increases with decreasing particle size; for nanometer-sized particles (e.g., viruses and proteins), the velocity on an air-water interface can be as large as approximately 47 m/s. We also show that particles oscillate at a relatively high frequency about their floating equilibrium before coming to stop under viscous drag. The observed dispersion is a result of strong repulsive hydrodynamic forces that arise because of these oscillations.
منابع مشابه
Separation of Ultra - Fine Sulphur Particles from Nta Dispersion by Aphron Flotation
Oxidative scrubbing is used to remove H2S from gas streams. A key problem in regeneration of the absorbent is the removal of fine particles of sulphur from the suspension of the scrubbing liquid. Dispersions of ultra-fine bubbles have been called "colloidal gas aphrons" or aphrons for short. These dispersions have interesting properties and it was found that they have particular advantages in t...
متن کاملEffect of colloidal Particles associated with the liquid bridge in sticking during drying in Superheated Steam
It is very important in the design of a drying system is to evaluate sticking behaviour of the materials goes under drying. A new approach to the sticking issue is applied in this study by carrying out a sticking test for the liquid associated with the materials under study. It was found that the liquid bridge is responsible of the initial sticking of the materials to the contact surface and th...
متن کاملControl Of C/Ti Ratio in Titanium Carbide - Copper Master Alloys Produced by SHS Reactions and its Effect on the Carbide Dispersion In Liquid Copper
Titanium carbide is used as an attractive reinforcement to produce particulate metal matrix composites. One of the problems to use this carbide as a reinforcement in copper-based composites is the lack of wetability in Cu-TiC system. This property improves as the C/Ti ratio in carbide decreases.
Problems to use this carbide as a reinforcement in copper-based composites is the lack of wetabii...
متن کاملControl Of C/Ti Ratio in Titanium Carbide - Copper Master Alloys Produced by SHS Reactions and its Effect on the Carbide Dispersion In Liquid Copper
Titanium carbide is used as an attractive reinforcement to produce particulate metal matrix composites. One of the problems to use this carbide as a reinforcement in copper-based composites is the lack of wetability in Cu-TiC system. This property improves as the C/Ti ratio in carbide decreases. Problems to use this carbide as a reinforcement in copper-based composites is the lack of wetabiity...
متن کاملDispersion and Deposition of Micro Particles over Two Square Obstacles in a Channel via Hybrid Lattice Boltzmann Method and Discrete Phase model
Dispersion and deposition of aerosol particles over two square cylinders confined in a channel in laminar unsteady vortical flow were investigated numerically. Lattice Boltzmann method was used to calculate fluid characteristics and modify Euler method was employed as Lagrangian particle tracing procedure to obtain particle trajectories. Drag, Saffman lift, gravity, buoyancy and Brownian motion...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Proceedings of the National Academy of Sciences of the United States of America
دوره 106 47 شماره
صفحات -
تاریخ انتشار 2009