Broadband and Omnidirectional Anti-reflection Layer for III/V Multi-junction Solar Cells
نویسندگان
چکیده
We report a novel graded refractive index antireflection coating for III/V quadruple solar cells based on bottom-up grown tapered GaP nanowires. We have calculated the photocurrent density of an InGaP-GaAs-InGaAsPInGaAs solar cell with a MgF2/ZnS double layer antireflection coating and with a graded refractive index coating. The photocurrent density can be increased by 5.9 % when the solar cell is coated with a graded refractive index layer with a thickness of 1 μm. We propose to realize such a graded refractive index layer by growing tapered GaP nanowires on III/V solar cells. For a first demonstration of the feasibility of the growth of tapered nanowires ∗Corresponding author ∗∗Principal corresponding author Email addresses: [email protected] (Silke L. Diedenhofen), [email protected] (Jaime Gómez Rivas) Present address: ICFO The Institute of Photonic Sciences, Av. Carl Friedrich Gauss, 3, 08860 Castelldefels (Barcelona), Spain. Preprint submitted to Elsevier October 25, 2012 on III/V solar cells, we have grown tapered GaP nanowires on AlInP/GaAs substrates. We show experimentally that the reflection from the nanowire coated substrate is reduced and that the transmission into the substrate is increased for a broad spectral and angular range.
منابع مشابه
Design of Silicon Nano-Bars Anti-Reflection Coating to Enhance Thin Film Solar Cells Efficiency
In this paper a novel anti-reflection (AR) coating based on silicon nano-bars is designed and its impact on the performance of crystalline silicon (c-Si) thin-film solar cells is extensively studied. Silicon nano-bars with optimized size and period are embedded on top of the active layer, under a 100nm Si3N4 layer. As a result of the proposed layer stack, an inhomogeneous intermediate layer wit...
متن کاملEfficiency Enhancement of Si Solar Cells by Using Nanostructured Single and Double Layer Anti-Reflective Coatings
The effect of single and double-layer anti-reflective coatings on efficiency enhancement of silicon solar cells was investigated. The reflectance of different anti-reflection structures were calculated using the transfer matrix method and then to predict the performance of solar cells coated by these structures, the weighted average reflectance curves were used as an input of a PC1D simulation....
متن کاملThe Effect of Change the Thickness on CdS/CdTe Tandem Multi-Junction Solar Cells Efficiency
Researchers in the field of simulation have been mainly interested in the question of how to increase the efficiency of solar cells. Therefore this study aimed to investigate CdS/CdTe solar cells by applying AMPS-1D software. The impact of semiconductor layers thickness on the output parameters of the CdS/CdTe solar cell is being analyzed and studied carefully, for example, fill factor, effici...
متن کاملNumerical Simulation of CdS/CIGS Tandem Multi-Junction Solar Cells with AMPS-1D
Numerical modeling of polycrystalline thin-film solar cell serves as an imperative procedure to test the suitability of proposed physical clarification and to anticipate the effect of physical changes on cell performance. All in all, this must be conducted with only partial knowledge of input parameters. In this paper, we evaluated the numerical simulation of CdS/CIGS tandem multi junction sola...
متن کاملEnhancing Efficiency of Two-bond Solar Cells Based on GaAs/InGaP
Multi-junction solar cells play a crucial role in the ConcentratedPhotovoltaic (CPV) Systems. Recent developments in CPV concerning high powerproduction and cost effective-ness along with better efficiency are due to theadvancements in multi-junction cells. This paper presents a simulation model of thegeneralized Multi-junction solar cell and introduces a two-bond solar ...
متن کامل