Modeling micro-end-milling operations. Part I: analytical cutting force model
نویسندگان
چکیده
A new analytical cutting force model is proposed for micro-end-milling operations. The model calculates the chip thickness by considering the trajectory of the tool tip while the tool rotates and moves ahead continuously. The proposed approach allows the calculation of the cutting forces to be done accurately in typical micro-end-milling operations with very aggressively selected feed per tooth to tool radius (ft/r) ratio. The difference of the simulated cutting forces between the proposed and conventional models can be experienced when ft/r is larger than 0.1. The estimated cutting force profile of the proposed model had good agreement with the experimental data. 2000 Elsevier Science Ltd. All rights reserved.
منابع مشابه
Modeling micro - end - milling operations . Part II : tool run - out
The effect of run-out is clearly noticed in micro-end-milling operations, while the same run-out creates negligible change at the cutting force profile of conventional end-milling operations. In this paper, the cutting force characteristics of micro-end-milling operations with tool run-out are investigated. An analytical cutting force model is developed for micro-end-milling operations with too...
متن کاملModeling micro-end-milling operations. Part III: influence of tool wear
The characteristics of the cutting forces were studied at different usage levels and the analytical model of the micro-end-milling operations was modified to represent the tool wear. A new expression was derived from the model to estimate the remaining tool life from experimental data. The parameters of the model are estimated by using genetic algorithms. The difference between the simulated an...
متن کاملDevelopment of Cutting Force Model by FEM Approach and Experimental Investigation of Tool Wear for CNC end Milling in Machining of Titanium alloy Ti-6Al-4V
This paper presents the development of a cutting force model for end milling process under various cutting conditions and the tool wear is measured by Scanning Electron Microscope (SEM).This novel approach combines the concept of experimental design and finite element modeling of the cutting process which allows for a fairly accurate prediction of cutting forces with a significantly lower compu...
متن کاملAn Instantaneous Rigid Force Model For 3-Axis Ball-End Milling Of Sculptured Surfaces
An instantaneous rigid force model for prediction of cutting forces in ball-end milling of sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...
متن کاملAnalytical Cutting Forces Model of Helical Milling Operations
Helical milling operations are used to generate or enlarge boreholes by means of a milling tool. The bore diameter can be adjusted through the diameter of the helical path. The kinematics of helical milling on a three axis machine tool is analysed firstly. The relationships between processing parameters, cutting tool geometry characters with machined hole feature are formulated. The feed motion...
متن کامل