Modification of Model Predictive Control to Reduce Cross-Coupling
نویسنده
چکیده
Abstract: We consider the problem of reducing interaction in the closed-loop response of model predictive control (MPC). Interaction in MPC may be caused by diagonal weighting of inputs in the MPC cost function that are not diagonally related to the outputs. If instead of weighting the plant inputs a suitable decoupled input signal is used in the MPC cost function, then a significant reduction in cross coupling can occur. In the case where the plant has a static interaction matrix, complete decoupling occurs. Simulation examples show that the procedure can be implemented via a simple modification to standard MPC algorithms, and is applicable to ill-conditioned and non-minimum phase plants.
منابع مشابه
Design of Generalized Predictive Control for the Stabilizing Loop from a two-axis Gimbal Seeker, Considering Cross-Coupling in Between two Channels
In this research, Generalized Predictivecontrol (GPC) is proposed for the control of a stabilizing loop from a two axis gimbal seeker. In fact, there are some views about using GPC type controller which are two folds. First, it drives the stabilization loops that are made by a DC motor, Rate Gyro, inertia and cross coupling unit in between two channels using the predictive model type controller...
متن کاملModified mathematical model for variable fill fluid coupling
Variable fill fluid couplings are used in the speed control units. Also, variation in coupling oil volume is used in adapting one size of coupling to a wider range of power transmission applications. Available model for the partially filled fluid couplings, has a good performance for couplings with fixed amount of oil but their performance will be degraded if they are used for the variable fill...
متن کاملModel Predictive Control of Distributed Energy Resources with Predictive Set-Points for Grid-Connected Operation
This paper proposes an MPC - based (model predictive control) scheme to control active and reactive powers of DERs (distributed energy resources) in a grid - connected mode (either through a bus with its associated loads as a PCC (point of common coupling) or an MG (micro - grid)). DER may be a DG (distributed generation) or an ESS (energy storage system). In the proposed scheme, the set - poin...
متن کاملطراحی کنترل کننده پیش بین سیستم بویلر- توربین
A nonlinear model predictive control (NMPC) algorithm based on neural network is designed for boiler- turbine system. The boiler–turbine system presents a challenging control problem owing to its severe nonlinearity over a wide operation range, tight operating constraints on control move and strong coupling among variables. The nonlinear system is identified by MLP neural network and neur...
متن کاملImproving the stability of the power system based on static synchronous series compensation equipped with robust model predictive control
Low-frequency oscillations (LFO) imperil the stability of the power system and reduce the Capacity of transmission lines. In the power systems, FACTS devices and Power System stabilizers are used to improve the stability. Static synchronous series compensators is one of the most important FACTS devices. This paper investigates the damping of LFO with static synchronous series compensator (SSSC)...
متن کامل