Phase Interrogation Used for a Wireless Passive Pressure Sensor in an 800 °C High-Temperature Environment
نویسندگان
چکیده
A wireless passive pressure measurement system for an 800 °C high-temperature environment is proposed and the impedance variation caused by the mutual coupling between a read antenna and a LC resonant sensor is analyzed. The system consists of a ceramic-based LC resonant sensor, a readout device for impedance phase interrogation, heat insulating material, and a composite temperature-pressure test platform. Performances of the pressure sensor are measured by the measurement system sufficiently, including pressure sensitivity at room temperature, zero drift from room temperature to 800 °C, and the pressure sensitivity under the 800 °C high temperature environment. The results show that the linearity of sensor is 0.93%, the repeatability is 6.6%, the hysteretic error is 1.67%, and the sensor sensitivity is 374 KHz/bar. The proposed measurement system, with high engineering value, demonstrates good pressure sensing performance in a high temperature environment.
منابع مشابه
Wireless chipless passive electromagnetic transducers for SHM applications
The energy autonomy of wireless sensors is crucial especially for buried or inaccessible sensors that are often the case in SHM applications. This problem can be overcome by using classical passive sensors (RFID or SAW sensors) but they suffer from a problem of low reading distances (<10m). For few years emerged a new kind of passive sensors using electromagnetic transducers, combining very hig...
متن کاملDielectrically-Loaded Cylindrical Resonator-Based Wireless Passive High-Temperature Sensor
The temperature sensor presented in this paper is based on a microwave dielectric resonator, which uses alumina ceramic as a substrate to survive in harsh environments. The resonant frequency of the resonator is determined by the relative permittivity of the alumina ceramic, which monotonically changes with temperature. A rectangular aperture etched on the surface of the resonator works as both...
متن کاملMicrowave Wire Interrogation Method Mapping Pressure under High Temperatures
It is widely accepted that wireless reading for in-situ mapping of pressure under high-temperature environments is the most feasible method, because it is not subject to frequent heterogeneous jointing failures and electrical conduction deteriorating, or even disappearing, under heat load. However, in this article, we successfully demonstrate an in-situ pressure sensor with wire interrogation f...
متن کاملSlot Antenna Integrated Re-Entrant Resonator Based Wireless Pressure Sensor for High-Temperature Applications
The highly sensitive pressure sensor presented in this paper aims at wireless passive sensing in a high temperature environment by using microwave backscattering technology. The structure of the re-entrant resonator was analyzed and optimized using theoretical calculation, software simulation, and its equivalent lump circuit model was first modified by us. Micro-machining and high-temperature c...
متن کاملA Cavity-less Micromachined Capacitive Pressure Sensor for Wireless Operation in Liquid Ambient
This paper reports a micromachined capacitive pressure sensor that does not use the traditional cavity and diaphragm, and its use in aqueous environment. The device is fabricated with two micromachined plates of stainless steel and an intermediate polymer layer that is soft enough to deform in the target pressure range. A polyurethane room-temperature-vulcanizing liquid rubber of 38-μm thicknes...
متن کامل