Influence of Initiation Strength, Ambient Inert Gas, Al-Content and Polymeric Binder on the Detonation Products of High Explosives
نویسنده
چکیده
منابع مشابه
مروری بر معادلات حالت مواد منفجره نسوخته
For simulation and analysis of detonation in explosive materials, we need to use equation of state (EOS) for closing of the governing equations. In high explosives, the EOS is divided into two categories, EOS of detonation products and unreacted materials. Most of the explosion specialists are familiar with EOS of detonation products. Therefore, this paper is about introducing and investigating...
متن کاملبررسی استفاده از پلیمرها و نرم کنندههای پرانرژی در ساخت مواد منفجره پلاستیکی حاوی HMX
Plastic Bonded Explosives with inert binder despite having good mechanical properties and low sensitivity, because of containing inert materials, have low energy level. So investigations for replacing inert binder system with energetic binder system and high exploding components in the making of these materials are performing. It seems using energetic polymers and materials like Cyclotetramethy...
متن کاملDetermination of the Parameters in HOM and BKW Equations of State for Detonation Products
One of the basic equations to analyze the detonation of high explosives is the equation of state of the detonation products. Due to the very high pressure of the product, the direct measurement of the thermodynamic variables such as pressure or temperature is not possible. In this research, the parameters of BKW and HOM equations of state of detonation products are determined via experimental m...
متن کاملDetermination of the Parameters in HOM and BKW Equations of State for Detonation Products
One of the basic equations to analyze the detonation of high explosives is the equation of state of the detonation products. Due to the very high pressure of the product, the direct measurement of the thermodynamic variables such as pressure or temperature is not possible. In this research, the parameters of BKW and HOM equations of state of detonation products are determined via experimental m...
متن کاملDetermination of BKW Equation of State Parameters via Measurement of the Detonation Velocity in Condensed Explosives
An optical system has been redesigned and used to measure detonation velocity as a function of condensed explosive density for RDX, HMX, PETN. These measurements are then used to determine and fine tune parameters appearing in the BKW (Beker-Kistiakowsky-Wilson) equation of state for gases at extremely high pressures. Steady state form of conservation equations along with the BKW state equation...
متن کامل