Imaging with microstructured polymer fibre.
نویسنده
چکیده
The imaging capabilities of a multicore microstructured polymer optical fibre with a square array of 112 air holes are demonstrated. Coherent imaging is achieved either by guiding light in polymer cores between air holes, or by guiding light in the air channels themselves. This potentially provides a miniaturised endoscope for medical applications, or a two-dimensional parallel optical data link for high-bandwidth interconnects.
منابع مشابه
Raman Spectra of a PMMA Microstructured Optical Fibre and Direct Measurement of Its Gain Coefficient
A polymethylmethacrylate (PMMA) microstructured polymer optical fiber (mPOF) is fabricated and characterized. Using the cut-back technique the fiber loss is measured which is higher than the step-index silica fibers. Through a novel experimental scheme, the backward Stokes spectrum of the fabricated mPOF is recorded over a range exceeding 3000 cm‑1 during the cut-back method and compared ...
متن کاملSolution doping of microstructured polymer optical fibres.
Solution doping of microstructured polymer optical fibres [mPOF] is demonstrated, a technique which allows dopants to be introduced after polymerisation through the microstructure. Controlled diffusion is used to disperse the dopant uniformly across the fibre core, and the final concentration can be systematically varied by appropriate choice of conditions. We use this technique to produce a fi...
متن کاملPoling and Doping of Microstructured Polymer Optical Fibres
Unlike conventional Polymer Optical Fibre (POF), single -mode Microstructured Polymer Optical Fibre (MPOF) can easily be fabricated, as required for many nonlinear applications. It was demonstrated that tungsten electrodes for poling and measuring the electro -optic coefficient could be incorporated in the PMMA fibre during the draw process. Lengths of up to 70m of this fibre were produced. For...
متن کاملFibre Bragg Gratings in Embedded Microstructured Optical Fibres Allow Distinguishing between Symmetric and Anti-Symmetric Lamb Waves in Carbon Fibre Reinforced Composites
Conventional contact sensors used for Lamb wave-based ultrasonic inspection, such as piezo-electric transducers, measure omnidirectional strain and do not allow distinguishing between fundamental symmetric and anti-symmetric modes. In this paper, we show that the use of a single fibre Bragg grating created in a dedicated microstructured optical fibre allows one to directly make the distinction ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics express
دوره 12 2 شماره
صفحات -
تاریخ انتشار 2004