An investigation of springback stresses in AISI-1010 deep drawn cups
نویسندگان
چکیده
The residual stresses created by deep drawing of AISI-1010 cups were investigated by means of neutron diffraction. The wall thickness of the cups was below 3.0 mm, for which 8–10 through-thickness measurements were conducted. It was found that the axial, and tangential stress profiles are similar to what is expected from a bending–unbending operation, but it also exhibits a strong dependence on the axial and, to a minor extent, on the circumferential position. The strong axial stress dependence reflects the effect of stretching while the weaker circumferential stress variations are due to sheet anisotropy. We also found that the thermal relief of cold work in the initial AISI-1010 cold rolled blank has no discernable effect both on the residual stresses and the springback. © 2005 Elsevier B.V. All rights reserved.
منابع مشابه
A synchrotron study of residual stresses in a Al6022 deep drawn cup
Fueled by pressures to reduce scrap and tooling costs, the modeling and prediction of springback has become a major focus of interest in sheet metal forming. Finite element codes and packages are being developed or improved but face the demand for higher predictive accuracy which, in turn, requires accurate property data and a more complete understanding of the stresses that are responsible for...
متن کاملEnergy Absorption Analysis and Multi-objective Optimization of Tri-layer Cups Subjected to Quasi-static Axial Compressive Loading
In this paper, the energy absorption features of tri-layer explosive-welded deep-drawn cups subjected to quasi-static axial compressive loading are investigated numerically and experimentally. To produce the cups, tri-layer blanks composed of aluminum and stainless steel alloys were fabricated by an explosive-welding process and formed by a deep drawing setup. The quasi-static tests were carrie...
متن کاملInvestigation of Effect of Phase Transformations on Mechanical Behavior of AISI 1010 Steel in Laser Forming
In laser forming, phase transformations in the heat affected zone take place under steep cooling rates and temperature gradients, and have a significant affect on the laser forming process and final mechanical properties of products. In this work, phase transformations during laser forming of AISI 1010 steel are experimentally and numerically investigated and the transient volume fraction of ea...
متن کاملSpringback optimization in automotive Shock Absorber Cup with Genetic Algorithm
Drawing or forming is a process normally used to achieve a required component form from a metal blank by applying a punch which radially draws the blank into the die by a mechanical or hydraulic action or combining both. When the component is drawn for more depth than the diameter, it is usually seen as deep drawing, which involves complicated states of material deformation. Due to the radial d...
متن کاملAnalysis of the Residual Stresses Distribution in the Case of Drawn Parts Made from Steel Sheets
The residual stresses that occur in the machined parts after the tools removing are the main cause that determines the springback of the draw parts made from metal sheets. Hence, to investigate this instability phenomenon it must be known the state of residual stresses developed in the part by its machining. But, the experimental investigation of the residual stress distribution in the case of ...
متن کامل