3D-Simulation and Experiment of Gas Penetration Length in Gas-Assisted Injection Molding
نویسندگان
چکیده
Gas-assisted injection molding process is much complicated,the process parameters have multiplied. In this paper, a product with typical character of gas-assisted injection molded part is employed as the object of study. With the mould of gas-assisted injection molding and MPI/3D GAS in Moldflow software,the influence rule of the 6 important process parameters on gas penetration length in gas-assisted injection molding (GAIM) were studied by the methods of physical experiment and 3D numerical simulation.
منابع مشابه
Experimental and Simulation - Assisted Feasibility Study of Gas Injection to Increase Oil Recovery Using a Combination of Semi-VAPEX and GAGD Techniques
Gas injection into heavy oil reservoirs could result in high ultimate recovery of oil. Experimental studies showed that an application of a combined technology of Gas Assisted Gravity Drainage (GAGD) and Vapor Extraction (VAPEX) could increase final oil recovery of a candidate viscous oil reservoir. In this paper the results of laboratory investigation are presented, including Pressure-Volu...
متن کاملSimulation of Dual Fuel Combustion of Direct Injection Engine with Variable Natural Gas Premixed Ratio
Nowadays, the major challenge of diesel engines development is simultaneous nitrogen oxides and soot emissions reduction without the thermal efficiency drop. Hence, different combustion concepts should be investigated to reach optimum emission and performance conditions in diesel engines without expensive aftertreatment systems. This paper presents the results of a study on a dual fuel (DF) eng...
متن کاملCapillary Effects on Surface Enhancement in a Non-Homogeneous Fibrous Porous Medium
The evaluation of a free fluid surface in a porous medium has several mathematical applications that are important in industries using molds, particularly in the fluid injection process. The vacuum-assisted resin transfer molding (VARTM) process is a promising technology in the primary composite industry. An accurate computational simulation of the VARTM process would be a cost-effective tool i...
متن کاملExperimental and Numerical Investigation of Thickness on the Shrinkage and out of Roundness in Cylindrical Parts in Injection Molding Process
Injection molding process is one of the most important methods of forming in the plastics manufacturing industry. Shrinkage and out of roundness are phenomenons that affect the final product quality. In this study, the effect of the thickness of cylindrical parts from polypropylene material on shrinkage and out of roundness has been investigated. For this purpose, injection molding process is s...
متن کاملInternal combustion engines in cylinder flow simulation improvement using nonlinear k-ε turbulence models
The purpose of this paper is to studying nonlinear k-ε turbulence models and its advantages in internal combustion engines, since the standard k-ε model is incapable of representing the anisotropy of turbulence intensities and fails to express the Reynolds stresses adequately in rotating flows. Therefore, this model is not only incapable of expressing the anisotropy of turbulence in an engine c...
متن کامل