High-frequency urban measurements of molecular hydrogen and carbon monoxide in the United Kingdom
نویسندگان
چکیده
High-frequency measurements of atmospheric molecular hydrogen (H2) and carbon monoxide (CO) were made at an urban site in the United Kingdom (UK) from mid-December, 2008 until early March, 2009. Very few measurements of H2 exist in the urban environment, particularly within the UK, but are an essential component in the assessment of anthropogenic emissions of H2 and to a certain extent CO. These data provide detailed information on urban time-series, diurnal cycles as well as sources and sinks of both H2 and CO at urban locations. High-frequency data were found to be strongly influenced by local meteorological conditions of wind speed and temperature. Diurnal cycles were found to follow transport frequency very closely due to the sites proximity to major carriageways, consequently a strong correlation was found between H2 and CO mole fractions. Background subtracted mean and rush hour molar H2/CO emission ratios of 0.53±0.08 and 0.57±0.06 respectively, were calculated from linear fitting of data. The scatter plot of all H2 and CO data displayed an unusual two population pattern, thought to be associated with a large industrial area 85 km to the west of the site. However, the definitive source of this two branch pattern could not be fully elucidated. H2 emissions from transport in the UK were estimated to be 188±39 Gg H2/yr, with 8.1±2.3 Tg/yr of H2 produced from vehicle emissions globally. H2 and CO deposition velocities were calculated during stable night-time inversion events when a clear decay of both species was observed. CO was found to have a much higher deposition velocity than H2, 1.3±0.8×10−3 and 2.2±1.5×10−4 m s−1 (1σ) respectively, going against the law of molecular diffusivity. The source of this unusual result was investigated, however no conclusive explanation was found for increased loss of CO over H2 during stable night time inversion events. Correspondence to: A. Grant ([email protected])
منابع مشابه
Preparation of Carbon Molecular Sieves from Pistachio Shell and Walnut Shell for Kinetic Separation of Carbon Monoxide, Hydrogen, and Methane
In this study, two Carbon Molecular Sieves using Pistachio shell (CMS P) and Walnut shell (CMS W) were prepared by a chemical vapor deposition method and used for pressure swing adsorption and separation of CO/H2 and CO/CH4. Adsorption isotherms of gases obtained for both CMS’s. The Dubinin-Radushkevich isotherm model was used for comparing pore volum...
متن کاملLong-term spatial and temporal variability of ambient carbon monoxide in Urmia, Iran
One of the pillars of epidemiologic research on the long-term health effects of air pollution is to estimate the chronic exposures over space and time. In this study, we aimed to measure the intra-urban ambient carbon monoxide (CO) concentrations within Urmia city in Iran, and to build a model within the geographic information system (GIS) to estimate the annual and seasonal means anywhere with...
متن کاملEnd-tidal Carbon Dioxide Measurements in Unintentional Non-Fire-Related Carbon Monoxide Poisoning
Background: Poisoning with carbon monoxide occurs occasionally worldwide, and the gold diagnostic standard is to measure carboxyhemoglobin level in the blood. This study investigated the correlation between carboxyhemoglobin and the end-tidal carbon dioxide levels in 50 patients with carbon monoxide poisoning. Methods: We recruited 50 volunteer patients who had been admitted to the Emergency S...
متن کاملModeling of carbon monoxide dispersion around the urban tunnel portals
The aim of this study is to investigate the problems caused by discharge of polluted air from tunnels into the environment with a specific focus on residential areas. In city tunnels, portal or stacks, pollutant management is a big challenge. Nowadays, air quality management, particularly in urban tunnels, is considered as a part of the ventilation system design. The goal is to see the environm...
متن کاملMolecular Simulation of Hydrogen Adsorption onto Single-Walled Carbon and Boron-Nitride Nano-Cones
In this paper, we have studied the hydrogen adsorption onto CNCs and BNNCs nano-cones using GCMC simulations. The effects of length and cone apex angle on adsorption property have been investigated. Our results show that with increasing the pressure and decreasing the cone length and cone apex angle except for CNC-300˚, the hydrogen adsorption onto the BNNCs and CNCs was increased. It was also ...
متن کامل