Fatty Acid-Based Monomers as Styrene Replacements for Liquid Molding Resins

One method of reducing styrene emissions from vinyl ester (VE) and unsaturated polyester resins (UPE) is to replace some or all of the styrene with fatty acid-based monomers. Methacrylated fatty acid (MFA) monomers are ideal candidates because they are inexpensive, have low volatilities, and free-radically polymerize with vinyl ester. The viscosity of VE resins using these fatty acid monomers ranged from 700– 2000 cP, which is considerably higher than that of VE/styrene resins (w100 cP). In addition, the Tg of VE/MFA polymers were only on the order of 80 8C, which is significantly lower than that of VE/styrene polymers. Decreasing the length of the base fatty acid chains from 18 to 12 carbon atoms improved the Tg by 20 8C, while lowing the resin viscosity from w2500 to w1000 cP. Residual unsaturation sites on the fatty acid backbone decreased the cure rate of the resins thereby decreasing polymer properties. Ternary blends of VE, styrene, and fatty acid monomers also effectively improved the flexural, fracture, and thermo-mechanical properties and reduced the resin viscosity to acceptable levels, while using less than 15 wt% styrene, far less than commercial VE resins. q 2004 Published by Elsevier Ltd.