Anomalous Thermal Behavior of CuxMg1-xNb2O6 (x=0,0.4,0.6,1) for LTCC Substrate

نویسندگان

  • Jyotirmayee Satapathy
  • M. V. Ramana Reddy
چکیده

LTCC (Low Temperature Co-fired Ceramics) being the most advantageous technology towards the multilayer substrates for various applications, demands an extensive study of its raw materials. In the present work, a series of CuxMg1-xNb2O6 (x=0,0.4,0.6,1) has been prepared using sol-gel synthesis route and sintered at a temperature of 900°C to study its applicability for LTCC technology as the firing temperature is 900°C in this technology. The phase formation has been confirmed using X-ray Diffraction. Thermal properties like thermal conductivity and thermal expansion being very important aspect as the former defines the heat flow to avoid thermal instability in layers and the later provides the dimensional congruency of the dielectric material and the conductors, are studied here over high temperature up to the firing temperature. Although the values are quite satisfactory from substrate requirement point view, results have shown anomaly over temperature. The anomalous thermal behavior has been further analyzed using TGDTA. Keywords—Niobates, LTCC, Thermal conductivity, Thermal expansion, TG-DTA.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fabrication of membranes and microchannels in low temperature co-fired ceramic (LTCC) substrate using novel water-based sacrificial carbon pastes

In this work, 3D structuration of LTCC (Low-Temperature Co-fired Ceramic) for microfluidics was studied, using two novel sacrificial carbon paste compositions. These pastes are based on graphite with a water-soluble vehicle consisting of polyvinylpyrrolidone binder (PVP) dissolved in propylene glycol (PG), which is not aggressive to green LTCC material. Both examined pastes differ slightly in b...

متن کامل

Thermal Assessment of RF Integrated LTCC Front End Module (FEM)

The thermal performance of Front End Module (FEM) incorporating Low Temperature Co-fired Ceramic (LTCC) substrate is investigated. An Infrared Microscope System was used to measure device surface temperature with both RF and DC power at various duty cycles (25 to 100%). The maximum junction temperature (~112°C) occurs at the second stage. By powering the module with DC only, the comparison betw...

متن کامل

Investigation of oxidation behavior and Thermal spray of mechanically milled CoNiCrAlY–YSZ powders

In this study, the effects of mechanical milling and YSZ reinforcing on oxidation behavior of CoNiCrAlY coatings were investigated. Various amounts of YSZ particles (0%, 5%, 10% and 15 wt.%) were mixed with commercial CoNiCrAlY powder and milled for 24 hrs. Then, the mechanically milled and commercial powders were deposited on Inconel 617 substrate using High Velocity Oxygen-Fuel (HVOF) process...

متن کامل

Rheological Behaviors and Their Correlation with Printing Performance of Silver Paste for LTCC Tape

Low Temperature Co-fired Ceramic (LTCC) technology has attracted much attention for high frequency applications due to the advantages in preparing 3D circuits within a ceramic block that enables burying of passive elements; resistor, inductor and capacitor (Jantunen et al., 2003). This technology also offers another advantages such as low fabrication cost due to parallel process, utilizing high...

متن کامل

Structuration of the Low Temperature Co-fired Ceramics (ltcc) Using Novel Sacrificial Graphite Paste with Pva-propylene Glycol-glycerol-water Vehicle Structuration of the Low Temperature Co-fired Ceramics (ltcc) Using Novel Sacrificial Graphite Paste with Pva-propylene Glycol-glycerol-water Vehicle

A novel formulation for thick-film graphite sacrificial pastes is studied in this paper. It is composed of coarse graphite powder (grain size: 25 μm), dispersed in a vehicle consisting of polyvinyl alcohol (PVA) dissolved in a propylene glycol (PG) – glycerol (G) – water mix, which is not aggressive to thin LTCC sheets. The presented sacrificial paste has been successfully applied for fabricati...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013