CMOS LNA for full UWB band

نویسندگان

  • Anh Tuan Phan
  • Ronan Farrell
چکیده

This paper presents a low voltage 2.8–11.2GHz CMOS broadband low noise amplifier (LNA) using folded common-gate (CG) topology. The broadband input matching is achieved by adopting CG topology. Bandwidth extension is proposed by inserting an inductor to create a broadband band-pass characteristic with a choke inductor. A folded topology is employed to reduce the supply voltage and thus power consumption. A source follower jointly acts as the buffer stage for broadband output impedance matching and feed-forward path for gain enhancement. Maximum power gain is 11.2 dB and the NF ranges from 2.58 to 4 dB over the full band. The LNA achieves an average IIP3 of −6.5 dBm while consumes only 4.6mW. The proposed broadband LNA is designed in 0.18-μm CMOS process from 1V supply.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Broadband Low Power CMOS LNA for 3.1–10.6 GHz UWB Receivers

A new approach for designing an ultra wideband (UWB) CMOS low noise amplifier (LNA) is presented. The aim of this design is to achieve a low noise figure, reasonable power gain and low power consumption in 3.1-10.6 GHz. Also, the figure of merit (FOM) is significantly improved at 180nm technology compared to the other state-of-the-art designs. Improved π-network and T-network are used to obt...

متن کامل

A 2-16 GHz CMOS Current Reuse Cascaded Ultra- wideband Low Noise Amplifier

This paper presents the design of a 2-16 GHz ultra wide band low noise amplifier (UWB LNA). The proposed LNA has a gain of 11.5 ± 0.85 dB with NF less than 2.82 dB. Good input and output impedance matching, good isolation and linearity are achieved over the operating frequency band. The proposed UWB LNA consumes 18.14 mW of power from 1.8V supply. This UWB LNA is designed and simulated in 0.18 ...

متن کامل

Design of Flat Gain and Low Noise Figure LNA for 3.1-10.2GHz Band UWB Applications in 0.18um CMOS Process

This paper shows the design of a broadband low noise amplifier (LNA) for ultra-wideband (UWB) system on 0.18um CMOS process. The proposed LNA uses resistive shunt feedback technique and an inter-stage inductor as an inductive peaking to realize the flat gain throughout the UWB band. The designed UWB LNA has a noise figure lower than 3.5dB, gain above 20dB in the frequency range 3. 1-10.2GHz. It...

متن کامل

Title of the Paper (18pt Times New Roman, Bold)

In this paper, the significance of linearity for UWB front-end circuit is discussed. The effects of strong narrow band interferer on UWB signal are investigated. Wideband linearization techniques for UWB LNA are first proposed in this work. A high linearity UWB LNA is designed in TSMC 0.18μ CMOS process The simulation results show that the designed LNA exhibits very high IIP3 (6.9~13.8 dBm) whi...

متن کامل

Design of Low Noise Amplifier for Uwb Radio Receiver

An Ultra Wide Band CMOS Low Noise Amplifier (LNA) design is presented in this paper. Due to low power consumption and extremely high data rates the UWB system is bound to be popular in the end user market. The LNA is the first stage after antenna in an UWB transceiver. The LNA is accountable for providing enough gain to the signal with the bare minimum distortion. In this work we have designed ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2009