DC-DC Converters Using PID Controller and Pulse Width Modulation Technique
نویسنده
چکیده
This paper presents a boost converter along with a flyback converter. The Zero Voltage Switching (ZVS) technique is used to achieve soft switching. A bidirectional boost converter is connected with an output module as a Parallel Input Serial Output configuration. The flyback converter with Voltage Doubler Rectifier (VDR) acts as an output module. This connection makes a bidirectional boost converter an active clamp circuit which is connected to the output side in order to extend the step up ratio. A converter with active clamp technique is used to recycle the leakage energy, to eliminate voltage spike due to coupled inductors and also to provide a mechanism to achieve ZVS. To overcome the efficiency degradation during light load due to load dependent soft switching of the ZVS, a control method using Pulse Width Modulation (PWM) proportional to the load current is used.
منابع مشابه
A New Intelligent Controller for Parallel DC/DC Converters
In this paper, the immune controller, is used to control the paralleled DC-DC converters. A PID controller is first applied and its coefficient is optimized using an intelligent (PSO) algorithm. Immune controller is then added to PID controller and an immune PID controller is formed. Two methods have been suggested to determine non-linear behavior of immune controller. In the first method, an e...
متن کاملGeneral Purpose Pulse Width Modulation Based Sliding Mode Controller for Buck DC-DC
This paper is a simple and systematic approaches to the design and analysis a pulse width modulation (PWM) based sliding mode controller for buck DC-DC Converters. Various aspects of the design, including the practical problems and the proposed solutions, are detailed. However, these control strategies can't compensate for large load current and input voltage variations. In this paper, a new co...
متن کاملAn Intelligent Algorithm based Controller for Multiple Output DC-DC Converters with Voltage Mode Weighting Factor
Multiple output DC-DC converters are widely used in many applications such as aerospace, industrial and medical equipments. The purpose of this paper is to present an intelligent control system for the multiple output DC-DC converters. In order to perform this purpose, a double ended forward DC-DC converter with three output voltages (+5 V/ 50W, +15 V/ 45W and -15 V/ 15W) is considered and anal...
متن کاملProximate Time-Optimal Digital Control for Synchronous Buck DC–DC Converters
This paper introduces an approach to near timeoptimal control for synchronous buck dc–dc converters. The proposed proximate time-optimal digital (PTOD) controller is a combination of a constant-frequency pulsewidth modulation (PWM) controller employing a linear PID compensator close to a reference point, and a linear or nonlinear switching surface controller (SSC) away from the reference, toget...
متن کاملSolar Water Pumping System
PV array is increasingly employed for water pumping system. In this paper, the developed boost converter steps up the voltage produced by the PV array to a value which is suitable to run a single-phase induction motor. The inverter converts DC to AC is controlled by using sinusoidal pulse width modulation (SPWM) technique. By using a LCfilter the harmonics are eliminated and pure sine wave is o...
متن کاملA High Efficiency Low-Voltage Soft Switching DC–DC Converter for Portable Applications
This paper presents a novel control method to improve the efficiency of low-voltage DC-DC converters at light loads. Pulse Width Modulation (PWM) converters have poor efficiencies at light loads, while pulse frequency modulation (PFM) control is more efficient for the same cases. Switching losses constitute a major portion of the total power loss at light loads. To decrease the switching losses...
متن کامل