Instantaneous Power Theory Based Active Power Filter: a Matlab/ Simulink Approach
نویسنده
چکیده
Power quality standards (IEEE-519) compel to limit the total harmonic distortion (THD) within acceptable range caused by rapid usage of power electronic equipment. This paper envisages on the simulation of instantaneous active and reactive theory based shunt active filter with MATLAB/ Simulink, as a better solution for reduction of the harmonics.
منابع مشابه
Simulation of three - phase bridge rectifier using MATLAB / SIMULINK for harmonic mitigation
Power quality standards (IEEE-519) compel to limit the total harmonic distortion (THD) within acceptable range caused by rapid usage of power electronic equipment. This paper envisages on the simulation of instantaneous active and reactive theory based shunt active filter with MATLAB/Simulink, as a better solution for reduction of the harmonics.
متن کاملImproving the performance of UPQC under unbalanced and distortional load conditions: A new control method
This paper presents a new control method for a three-phase four-wire Unified Power Quality Conditioner (UPQC) to deal with the problems of power quality under distortional and unbalanced load conditions. The proposed control approach is the combination of instantaneous power theory and Synchronous Reference Frame (SRF) theory which is optimized by using a self-tuning filter (STF) and without us...
متن کاملSimulink Library for Reference Current Generation in Active DC Traction Substations
This paper is focused on the reference current calculation in the compensation mode of the active DC traction substations. The so-called p-q theory of the instantaneous reactive power is used as theoretical foundation. The compensation goal of total compensation is taken into consideration for the operation under both sinusoidal and nonsinusoidal voltage conditions, through the two objectives o...
متن کاملA New Approach Based on Instantaneous Power Theory for Improving the Performance of UPQC Under Unbalanced and Distortional Load Conditions
In order to deal with power quality problems under distortional and unbalanced load conditions, this paper presents a new control method for a four-wire three-phase unified power quality conditioner (UPQC) which is based on instantaneous power p-q theory. The proposed control approach is based on instantaneous power and is optimized by using a self-tuning filter (STF), without using any low-pas...
متن کاملAnalysis And Simulation Of Shunt Active Power Filter Under Unbalanced And Distorted Load Conditions
Abstract— The active power filters eliminates the harmonic distortion caused by non-linear loads and improves the filtering efficiency performance when compared with the passive filters. This paper inspects about the analysis and simulation of a three phase four wire shunt active power f ilter under unbalanced and distorted load conditions. Current harmonic compensation is achieved by the imple...
متن کامل