Overcoming the challenges of designing optimized broadband vibroseis sweeps
نویسندگان
چکیده
Our sweep design methodology centers on creating a frequency dependent force-amplitude (drive) function such that the drive-level at each frequency is maximised but does not exceed the mechanical limitations of the vibrator. Bagaini (2008) showed how we can overcome the reduction in energy from reducing the drive-level by increasing the instantaneous sweep rate. This methodology has commonly been used to enhance the low-frequency content of the sweep but can be applied across the full sweep bandwidth.
منابع مشابه
Orthogonal sweeps of vibroseis
Vibroseis is a method that imparts coded seismic energy into the ground. The energy is recorded with geophones and then processed using the known (coded) input signal. The resulting time-domain representation of vibroseis data is an impulsive wavetrain with wavelet properties consistent with the coded input signal convolved with the earth’s reflectivity series. Historically vibratory seismic su...
متن کاملAn Investigation of LTE Broadcast
Broadcast and broadband communications have undoubt- edly become a part of today’s social life. Accessibility of content of interest to the audience at any place and at any time regardless of the type of content consumer device can have an effective contribution to the desire of the audience to use of the broadcast content. The HD and Ultra HD qualities, the desire for demand-driven application...
متن کاملAn Investigation of LTE Broadcast
Broadcast and broadband communications have undoubt- edly become a part of today’s social life. Accessibility of content of interest to the audience at any place and at any time regardless of the type of content consumer device can have an effective contribution to the desire of the audience to use of the broadcast content. The HD and Ultra HD qualities, the desire for demand-driven application...
متن کاملVibroseis Deconvolution with Maximum Likelihood Approach
The most commonly used deconvolution (Decon) method is based on minimum-phase assumption for the wavelet which is often not valid. Explosive energy source is close to minimum-phase which makes seismic data with explosive somewhat amenable to predictive Decon though the result is imperfect in phase. Decon of Vibroseis data is more problematic because the wavelet in a correlated Vibroseis trace i...
متن کاملSlice-selective broadband refocusing pulses with B1 immunity
Introduction: Broadband refocusing pulses are of great interest for reducing chemical shift displacements, anomalous J modulation, and increasing spectral selectivity. The design of refocusing pulses with broad bandwidth in the presence of limited RF power was accomplished with the Shinnar-Le Roux (SLR) transformation in combination with zero-flipping [1]. Schulte et al. optimized for maximum p...
متن کامل