Task-specific monitoring of nuclear medicine technologists' radiation exposure.
نویسنده
چکیده
Many studies have demonstrated that the exposure of nuclear medicine technologists arises primarily from radioactive patients rather than from preparation of radiopharmaceuticals. However, in order to devise strategies to reduce staff exposure, it is necessary to identify the specific tasks within each procedure that result in the highest radiation doses. An ESM Eberline FH41B-10 radiation dosemeter, which records the ambient dose equivalent rate, was used to monitor the radiation exposure of a technologist and to record the dose rate in microSv per hour every 32 s throughout a working day. The technologist recorded the procedures that were being performed so that the procedures that resulted in higher doses could be identified clearly. The measured doses clearly showed that the major contributions to the technologist's dose were the following: (1) transferring incapacitated patients from the imaging table to a hospital trolley; (2) difficult injections without syringe shields; and (3) setting up patients for gated myocardial scans. The average dose to the technologist from transferring patients after a bone scan was 0.54 microSv, 40% of the total dose of 1.3 microSv for the complete bone scan procedure. The average dose received injecting 900 MBq of 99Tcm-HDP using a tungsten syringe shield was 0.57microSv, but the highest dose was 1.6 microSv, in a patient in whom the injection was difficult. A 0.5 mm lead apron was found to reduce the dose when setting up a patient for a gated stress 99Tcm-sestamibi myocardial scan by approximately a factor of 2. The average dose per patient for this task was reduced from 1.1 to 0.6 microSv. It is recommended that staff waiting for assistance with patient transfers stand away from the patient, that tungsten syringe shields be used for all radiopharmaceutical injections and that a 0.5 mm lead apron be worn when attending patients containing high activities of 99Tcm radiopharmaceuticals, such as those having myocardial imaging.
منابع مشابه
Active Personal Dosimeter in a Nuclear Medicine Center in Yazd City, Iran
Introduction: Active personal dosimeters (APDs) are well accepted as useful and reliable instruments for individual dosimetry measurements. APDs have many advantages compared with passive dosimeters for individual external radiation dose assessments. In routine monitoring, occupational exposure is carried out for verification and demonstration of compliance with the regulatory dose limits. So, ...
متن کاملExternal radiation dose from patients received diagnostic doses of ²º¹Tl-Chloride and 99mTc-MIBI [Persian]
Patients receiving diagnostic doses of radiopharmaceuticals become a source of contamination and exposure for those who come in contact with them, such as nuclear medicine technologists, relatives and nurses. Therefore, the measurement of external radiation dose from these patients is necessary. In this study, the dose rates at distances of 10, 50 and 100cm from 70 patients who received d...
متن کاملRadiation dose to PET technologists and strategies to lower occupational exposure.
OBJECTIVE The use of PET in Australia has grown rapidly. We conducted a prospective study of the radiation exposure of technologists working in PET and evaluated the occupational radiation dose after implementation of strategies to lower exposure. METHODS Radiation doses measured by thermoluminescent dosimeters over a 2-y period were reviewed both for technologists working in PET and for tech...
متن کاملBasic Review of Radiation Biology and Terminology.
The purpose of this paper is to review basic radiation biology and associated terminology to impart a better understanding of the importance of basic concepts of ionizing radiation interactions with living tissue. As health care workers in a field that utilizes ionizing radiation, nuclear medicine technologists are concerned about the possible acute and chronic effects of occupational radiation...
متن کاملReview of common occupational hazards and safety concerns for nuclear medicine technologists.
The purpose of this article is to address common occupational hazards and safety concerns of nuclear medicine technologists. There are many possible occupational hazards, but this review is intended to concentrate on common hazards and safety concerns. These include radiation safety issues and concerns about the possibility of developing latent diseases, such as eye cataracts or cancer; pregnan...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Radiation protection dosimetry
دوره 109 3 شماره
صفحات -
تاریخ انتشار 2004