Design and Implementation of Microstrip Antenna for RF Energy Harvesting
نویسنده
چکیده
This paper describes the antenna design for RF power harvesting system. The design goes through three phases designing of antenna, matching network and rectifier. A dual band Microstrip antenna suspended above ground plane is designed to operate in GSM 1.8 and ISM 2.4 GHz bands. The antenna incorporates the capacitive feed strip which is fed by coaxial probe technique where the inductive impedance of probe is effectively cancelled by the capacitive patch. The designed antenna provides good frequency response and fairly directional radiation pattern. For designing and simulation of proposed antenna we have used IE3D software.
منابع مشابه
Bio-inspired optimization algorithms applied to rectenna design
*Correspondence: [email protected] Department of Electric engineering, Xi’an Jiaotong-Liverpool University, Ren’ai road 111, Suzhou, People’s Republic of China Abstract A comparative study of the use of bio-inspired optimization technologies including the Cuckoo Search (CS) algorithm, the Differential Evolution (DE) algorithm, and Quantum-behaved Particle Swarm Optimization (QPSO) in the ...
متن کاملDevelopment of RF Energy Harvesting and Charging Circuits for Low Power Mobile Devices
The electrical power generated by RF energy harvesting techniques is small, depending on techniques it is enough to drive low power consumption devices. Therefore, it is possible to increase the battery life and to reduce the environmental pollution. In this paper, we focus on the RF energy harvesting and design the rectenna with a 4×4 patch antenna of 2.13 GHz for low power mobile devices. The...
متن کاملA Capacitive Fed Microstrip Patch Antenna with Air Gap for Wideband Applications (RESEARCH NOTE)
In this paper a microstrip antenna on a suspended substrate with capacitive feed is presented. capacitive feed is created by a slot within the rectangular patch around the feed point. The proposed antenna exhibits a much higher impedance bandwidth of about 47% (S11 < −10 dB). Effects of key design parameters such as the air gap between the substrate and the ground plane, the gap width between r...
متن کاملAntenna Design and Non Linear Simulation of Rectifier for Wideband and Multi-Tone Radio Frequency Energy Harvesting
In this paper, a wideband rectenna without using matching networks is presented. In addition of wide bandwidth, the omnidirectional radiation pattern, maximum radio frequency to dc conversion efficiency, harvesting capability of the minimum input power level, easy fabrication process cause this antenna be a good choice for radio frequency energy harvesting applications. Matching network has bee...
متن کاملDesign and Miniaturization of a Novel Fractal Microstrip Antenna for UWB Applications
A novel printed octagonal fractal microstrip antenna with semi-elliptical ground plane is presented for ultra wide band applications. The proposed antenna has a compact size of 20×20×1 mm³. The measured result of the antenna exhibits the ultra wide band characteristics from 2/9 to 14/2 GHz. In this paper, reducing antenna’s size by 35%, the same results were achieved, while small dimension frac...
متن کامل