Persistent holes in a fluid.
نویسندگان
چکیده
We observe stable holes in a vertically oscillated 0.5 cm deep aqueous suspension of cornstarch. Holes appear only if a finite perturbation is applied to the layer for accelerations a above 10g. Holes are circular and approximately 0.5 cm wide, and can persist for more than 10(6) cycles. Above a approximately equal to 17g the rim of the hole becomes unstable, producing fingerlike protrusions or hole division. At higher acceleration, the hole delocalizes, growing to cover the entire surface with erratic undulations. We find similar behavior in an aqueous suspension of glass microspheres.
منابع مشابه
A new approach to enhance final surface quality in drilling operation: evaluation of using alumina micro-particle additives on oil-water emulsion cutting fluid
Reaming is a common finishing process for improving the drilled holes surface quality. Choosing an appropriate finishing method in drilling process has a significant effect on the surface quality of holes and in decreasing the process total cost and time. In this study, four similar holes were drilled on the AISI 4340 workpiece with different two pair feed rates. The drilling process was perfor...
متن کاملMacular detachment for treatment of persistent macular hole.
The authors report a technique for treatment of persistent macular holes in cases refractory to traditional surgical techniques. With a standard pars plana vitrectomy approach, subretinal infusion of balanced salt solution was performed and followed by a fluid-air exchange. This intervention resulted in hole closure despite poor prognosis and may be considered as a treatment option for patients...
متن کاملInfluence of insertion of holes in the middle of obstacles on the flow around a surface-mounted cube
The aim of our study is to analyze the impact of insertion holes in the middle of obstacles on the flow around a surface-mounted cube, In order to do this; we studied four configurations of obstacles in a channel with a Reynods number based on obstacle height ReH = 40000. The hexahedral structured meshes were used to solve the fluid dynamics equations .The finite volume method are employed to s...
متن کاملThermal Performance of Jet Impingement with Spent Flow Management
The present study proposes novel micro-jet impingement heat sink with effusion holes for flow extraction. The design consists of impingement nozzles surrounded by multiple effusion holes to take away the spent fluid. A three-dimensional numerical model is used for steady, incompressible, laminar flow and conjugate heat transfer for the performance analysis of the proposed design. The computatio...
متن کاملThe phase transition of corrected black hole with f(R) gravity
In this letter, we consider static black hole in f(R) gravity.We take advantage from corrected entropy and temperature and investigate such black hole. Finally, we study the $ P - V $ critically and phase transition of corrected black hole with respect to entropy and temperature. Here also, we obtain the heat capacity for the static black hole in $ f(R) $ gravity. This calculation help us...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Physical review letters
دوره 92 18 شماره
صفحات -
تاریخ انتشار 2004