Wetting of mono and few-layered WS2 and MoS2 films supported on Si/SiO2 substrates.
نویسندگان
چکیده
The recent interest and excitement in graphene has also opened up a pandora's box of other two-dimensional (2D) materials and material combinations which are now beginning to come to the fore. One family of these emerging 2D materials is transition metal dichalcogenides (TMDs). So far there is very limited understanding on the wetting behavior of "monolayer" TMD materials. In this study, we synthesized large-area, continuous monolayer tungsten disulfide (WS2) and molybdenum disulfide (MoS2) films on SiO2/Si substrates by the thermal reduction and sulfurization of WO3 and MO3 thin films. The monolayer TMD films displayed an advancing water contact angle of ∼83° as compared to ∼90° for the bulk material. We also prepared bilayer and trilayer WS2 films and studied the transition of the water contact angle with increasing number of layers. The advancing water contact angle increased to ∼85° for the bilayer and then to ∼90° for the trilayer film. Beyond three layers, there was no significant change in the measured water contact angle. This type of wetting transition indicates that water interacts to some extent with the underlying silica substrate through the monolayer TMD sheet. The experimentally observed wetting transition with numbers of TMD layers lies in-between the predictions of one continuum model that considers only van der Waals attractions and another model that considers only dipole-dipole interactions. We also explored wetting as a function of aging. A clean single-layer WS2 film (without airborne contaminants) was shown to be strongly hydrophilic with an advancing water contact angle of ∼70°. However, over time, the sample ages as hydrocarbons and water present in air adsorb onto the clean WS2 sheet. After ∼7 days, the aging process is completed and the advancing water contact angle of the aged single-layer WS2 film stabilizes at ∼83°. These results suggest that clean (i.e., nonaged) monolayer TMDs are hydrophilic materials. We further show that substitution of sulfur atoms by oxygen in the lattice of aged monolayer WS2 and MoS2 films can be used to generate well-defined 'hydrophobic-hydrophilic' patterns that preferentially accumulate and create microdrop arrays on the surface during water condensation and evaporation experiments.
منابع مشابه
Tunable Wetting Property in Growth Mode-Controlled WS2 Thin Films
We report on a thickness-dependent wetting property of WS2/Al2O3 and WS2/SiO2/Si structures. We prepared WS2 films with gradient thickness by annealing thickness-controlled WO3 films at 800 °C in sulfur atmosphere. Raman spectroscopy measurements showed step-like variation in the thickness of WS2 over substrates several centimeters in dimension. On fresh surfaces, we observed a significant chan...
متن کاملControlled synthesis and transfer of large-area WS2 sheets: from single layer to few layers.
The isolation of few-layered transition metal dichalcogenides has mainly been performed by mechanical and chemical exfoliation with very low yields. In this account, a controlled thermal reduction-sulfurization method is used to synthesize large-area (~1 cm(2)) WS2 sheets with thicknesses ranging from monolayers to a few layers. During synthesis, WOx thin films are first deposited on Si/SiO2 su...
متن کاملOptical investigation of the natural electron doping in thin MoS2 films deposited on dielectric substrates
Two-dimensional (2D) compounds provide unique building blocks for novel layered devices and hybrid photonic structures. However, large surface-to-volume ratio in thin films enhances the significance of surface interactions and charging effects requiring new understanding. Here we use micro-photoluminescence (PL) and ultrasonic force microscopy to explore the influence of the dielectric environm...
متن کاملVisibility of atomically-thin layered materials buried in silicon dioxide.
Recently, the coating of thin oxide or nitride film on top of crystals of atomically-thin layered material (ATLM) has been introduced, which benefits optical and electrical properties of the materials and shields them from environmental contact, and has important implications for optoelectronics applications of layered materials. By calculating the reflection contrast, we show the possibility o...
متن کاملDetermining layer number of two-dimensional flakes of transition-metal dichalcogenides by the Raman intensity from substrates.
Transition-metal dichalcogenide (TMD) semiconductors have been widely studied due to their distinctive electronic and optical properties. The property of TMD flakes is a function of their thickness, or layer number (N). How to determine the N of ultrathin TMD materials is of primary importance for fundamental study and practical applications. Raman mode intensity from substrates has been used t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- ACS nano
دوره 9 3 شماره
صفحات -
تاریخ انتشار 2015