Optimization Analysis of Feedforward Power Amplifier
نویسندگان
چکیده
The efficiency optimization of a feedforward low distortion power amplifier is presented. Based on the principle of distortion compensation, the main amplifier output power, that of subamplifier, and amplifier efficiency have been accurately derived. In the present analysis, the coupling coefficient of main signal and distortion paths is selected as the optimization parameter because it may essentially affect the amplifier performance. Simulation results have been obtained for different values of signal cancel ratio and adjacent channel leakage power. The analysis contributes to the design improvement of a power amplifier of mobile communication base stations.
منابع مشابه
A Novel Resistive Capacitive Feedback Trans-impedance Amplifier Optimization Using IPSO Algorithm
A novel low noise trans-impedance amplifier is proposed using low cost 0.18 µm CMOS technology. A resistive-capacitive feedback is used to extend the bandwidth of the amplifier. As the structure is inductor less, it is suitable for low cost integrated optical interconnects. In this paper Improved Particle Swarm Optimization have applied to determine optimal trans-resistance and noise of propose...
متن کاملDesign of Adaptive Feedforward Linear Power Amplifier for Wireless Communication
Abstract The performance of a wireless communication system depends on amplifier’s nonlinearity. Adaptive feed-forward amplifier implementation for wideband communication system and a step by step design of power amplifier at 2.4 GHz are introduced. The Feedforward linearization and Adaptive feedforward technique is a well known power amplifier linearization method to reduce out-of band distort...
متن کاملNonlinear Analysis of a Power Amplifier inc C Band and Load Pull Technique Calculation USING VOLTERRA SERIES
In recent years, nonlinear circuit analysis techniques have been extensively investigated. One of the most important reasons is the application development of solid-state devices at microwave frequencies. Different methods have been used to analysis large signal behavior of these devices. In this paper load-pull curves (one of design requirement) are obtained using Volterra series. The main adv...
متن کاملDesign and Fabrication of a 911 GHz Balanced Low Noise Amplifier Using HJFET
This paper describes the design of an X-band balanced low noise amplifier (LNA) using an available HJFET device. The balanced LNA consists of a pair of electrically similar transistors whose input and output signals are divided or combined by 3 dB two-stage Wilkinson power dividers. The proposed balanced LNA is fabricated and measured. The measured results show that the noise figure is 1.30 dB ...
متن کاملNon-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کامل