Optimization on drying conditions of a solar electrohydrodynamic drying system based on desirability concept
نویسندگان
چکیده
The purpose of this article was to present a new drying method for agricultural products. Electrohydrodynamic (EHD) has been applied for drying of agricultural materials due to several advantages such as energy saving, low cost equipment, low drying temperatures, and superior material quality. To evaluate this method, an EHD dryer based on solar (photovoltaic) energy was designed and fabricated. Moreover, the optimum condition for the EHD drying of kiwi fruit was studied by applying the Box-Behnken design of response surface methodology. The desirability function was applied for optimization in case of single objective and multiobjective functions. By using the multiobjective optimization method, maximum desirability value of 0.865 was obtained based on the following: applied voltage of 15 kV, field strength of 5.2 kV cm(-1), without forced air stream, and finally a combination of 17 discharge electrodes (needles). The results indicated that increasing the applied voltage from 6 to 15 kV, moisture ratio (MR) decreased, though energy efficiency and energy consumption were increasing. On the other hand, field strength of 5.2 kV cm(-1) was the optimal point in terms of MR.
منابع مشابه
Design and optimization of solar-assisted conveyer-belt dryer for biomass
Biomass, as a renewable source of energy, can be used in many industries to reduce their dependence on fossil fuels. However, due to the significantly high and varied moisture content of biomass, its use has several drawbacks, such as low total efficiency and process instability. Drying biomass before combustion or gasification can eliminate these drawbacks. Besides these benefits, there ar...
متن کاملModeling of electrohydrodynamic drying process using response surface methodology
Energy consumption index is one of the most important criteria for judging about new, and emerging drying technologies. One of such novel and promising alternative of drying process is called electrohydrodynamic (EHD) drying. In this work, a solar energy was used to maintain required energy of EHD drying process. Moreover, response surface methodology (RSM) was used to build a predictive model ...
متن کاملDrying of Matricaria recutita Flowers in Vibrofluidized Bed Dryer: Optimization of Drying Conditions Using Response Surface Methodology
Drying of Matricaria recutita flower was investigated experimentally in a VibroFluidized Bed Dryer (VFBD). The aim of the present work was to optimize the best operating conditions for the drying of Matricaria recutita flower in the VFBD based on experimental design techniques. Response Surface Methodology (RSM) and Central Composite Design (CCD) based on 4-variable with 5-level have been e...
متن کاملHeat and Mass Transfer in Leather Drying Process
Leather manufacturing involves a crucial energy-intensive drying stage in the finishing process to remove its residual moisture. Determining drying characteristics of leather is vitally important so as to optimize the drying stage. This paper describes an analytical way for determination of the drying characteristics of leather. The model presented, is based on fundamental heat and mass tra...
متن کاملبررسی سینتیک خشک شدن زیره سبز در یک خشک کن خورشیدی در دو حالت تابش مختلط و غیرمستقیم
In this work, a cabinet solar dryer for thin layer drying of Cuminum cyminum was evaluated in two conditions (Indirect and Mixed). Four levels of drying air flow rates (three active and one passive) were adopted. The experiments were performed in a completely randomized Block design pattern in three replications. Drying durations were kept constant (90 min) for all the experiments. Average init...
متن کامل